User manual ZANUSSI DF6926

[. . . ] 9. Water hardness adjustment Levelling spacers Upper basket stop Salt container Large filter Detergent dispenser Control panel Rating plate Rinse aid dispenser 11. Central filter 13 The control panel 1. 3. On/Off indicator light On/Off push button Main wash temperature push button (50°) Half load push button By pressing this push button washing can be confined to the only lower basket. [. . . ] The On/Off indicator light remains on until the On/Off push button is depressed. 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 10. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off push button. Wait 15/20 minutes before opening the dishwasher's door; in this way you will avoid burning yourself when removing the dishes and avoid also the damage of the nearby furniture caused by the escape of steam. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 4. Ensure that the spray arms can rotate freely 5. Measure out detergent Add the detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. 6. Set the programme Push the programme selector dial to make it pop out. Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. If necessary select the temperature of the main wash (or a half load programme) according to the instructions in the "Washing programmes" chart (see "Required push buttons"). Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 16 Using your appliance Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. [. . . ] Proceed as follows: - Remove the machine's worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. 570 - 600 600 IN05 Levelling Good levelling is essential for correct closure and sealing of the door. [. . . ]