User manual ZANUSSI DF6937

[. . . ] 9. Water hardness adjustment Levelling spacers Upper basket stop Salt container Large filter Detergent dispenser Control panel Rating plate Rinse aid dispenser 11. Central filter 14 The control panel 1. 3. On/Off indicator light On/Off push button Main wash temperature push buttons (50° - 70°) Half load push button By pressing this push button washing can be confined to the only lower basket. [. . . ] Check that there is rinse aid and salt (See "Instruction book" - part 1) 9. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. The On/Off indicator light remains on until the On/Off push button is depressed. 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 10. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off push button. Wait 15/20 minutes before opening the dishwasher's door; in this way you will avoid burning yourself when removing the dishes and avoid also the damage of the nearby furniture caused by the escape of steam. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 4. Ensure that the spray arms can rotate freely 5. Measure out detergent Add the detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. 6. Set the programme Push the programme selector dial to make it pop out. Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. If necessary select the temperature of the main wash (or a half load programme) according to the instructions in the "Washing programmes" chart (see "Required push buttons"). Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 17 Using your appliance Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. [. . . ] Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it. After loading your machine always close the door, as an open door can be a hazard. 20 Hints for test centres Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser. Test standard: Reference programme: Load: Rinse aid selector: Detergent dosage: EN 50242 Bio 50°C with prewash 12 standard place settings position 5 25 g in the dispenser 5 g on the dispenser lid Arrangement upper basket Arrangement lower basket Arrangement cutlery basket Technical specifications Dimensions Width Height with worktop Height without worktop Max depth Max depth with open door Voltage 60 cm 85 cm 82 cm 60 cm 115. 2 cm 230 V - 50 Hz 200 W 2100 W 2300 W 50 kPa (0. 5 bar) 800 kPa (8 bar) max. 60°C 12 place settings Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure Water supply connection Capacity Minimum Maximum Water cold/hot 21 Fitting under a counter (kitchen worktop or sink) By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. [. . . ]