User manual ZANUSSI DR50/2/B

[. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. [. . . ] For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. 12 I nstructions for totally built-in appliances Door reversibility (Fig. 1) P P 1 2 3 P1 D607 P1 Right opening Remove the pins (P) and (P1) Left opening Remove (P) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (P) on the left side. Remove pin (P1 ) from the right side. I nstructions for totally built-in appliances min. 200 cm 2 Dimensions of the recess Height Depth Width 1446 mm 550 mm 560 mm 50 mm Fig. cm 200 2 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. The appliance will start to operate. GB Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position «O». Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Place the food to be frozen in the top basket of the freezing compartment as this is the coldest part. The maximum quantity of food which can be frozen in 24 hrs is shown on the rating plate. Only freeze top quality, fresh and thoroughly cleaned foodstuffs. Prepare the fresh food in small portions to enable it to be rapidly and completely frozen and to make it possible subsequently to thaw only the quantity required at the time. Wrap up the food in aluminium foil or polythene and make sure that the packages are airtight. It is advisable to show on the single food packet or on the write-on produce strips to be found on the front part of the storage baskets the freezing-in date to enable you to keep date of the storage time. [. . . ] Position food so that air can circulate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer(s). For safety, store in this way only one or two days at the most. After two or three hours, reload the previously removed food into the compartment. [. . . ]