User manual ZANUSSI DR56/2/B

[. . . ] Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings or these warnings contact the Customer Care Department. Prior to installation Check the appliance for transport damage. Under no circumstances should a damaged appliance be installed. [. . . ] Food which is to be frozen (when cool) should be placed in the fridge compartment before being transferred to the freezer compartment. Try to avoid keeping the door open for long periods or opening the door too frequently as warm air will enter the cabinet and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. Food Storage To obtain the best performance from your appliance: Do not store warm food or evaporating liquid. Avoid buying frozen food if you cannot store it straight away. The use of an insulated container is advisable. When you arrive home, place the frozen food in the freezer compartment immediately. Ensure that food placed in the freezer compartment is dated and labelled and used in date order to ensure that food is consumed at its best. Lean food keeps better and longer than fatty food, salt reduces the storage time. Wrap the food in polythene or aluminium freezing bags or foil so that they adhere to the food and provide an airtight seal. Packaging which is swollen or has traces of refrozen water droplets on the pack could indicate that the product has not been kept at a suitable temperature and that it may have lost its original quality. Partially thawed food must not be refrozen, it must be consumed within 24 hours. To accelerate defrosting, place a bowl of hot water inside the compartment (with a piece of cardboard underneath the bowl as protection). Remove any loose pieces of ice as soon as possible. 9 Changing the Light Bulb Should the light fail to work you can change it as below: Disconnect the appliance from the electricity supply. Remove the lamp cover retaining screws, then take the lamp cover off in the direction of the arrow and the bulb can be changed. (Type of the bulb: 230 V, 15 W, E 14 thread) After changing the bulb replace the lamp cover, and retaining screws and reconnect the appliance to the electricity supply. When the appliance is not in use When the appliance is not in use for long periods disconnect from the electricity supply, empty all of the food and clean the appliance, leaving the door ajar to prevent unpleasant smells. Some thing N o t Wor king If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Problem No power to the appliance Possible Cause No power at the socket. The appliance is located in an unsuitable position. The temperature in the appliance is too low Excessive frost and ice has built up The appliance is noisy. The purchase date Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. Cus t omer Car e Depar tment For general enquiries concerning your Zanussi Electrolux appliance or for further information on Zanussi Electrolux products, please contact our Customer Care Department by letter or telephone at the adresses below or visit our website at www. zanussi. co. uk Customer Care Department Zanussi Electrolux 55-77 High Street Slough Berkshire SL1 1DZ 08705 727727 (*) *calls to this number may be recorded for training purposes. 11 Guar ant ee Conditions We Zanussi Electrolux undertake that if within 12 months of the date of the purchase this ZANUSSI ELECTROLUX appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electrical supply stated on the rating plate. The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. [. . . ] Unscrew the hinge pin from the hinge plate and reinsert on the opposite side of the pate. Rotate the hinge assembly 180° and insert the hinge assembly into the opposite location. Refit the 2 hinge plate retaining screws. Relocate the worktop and refit the worktop retaining screws. To reverse the handle proceed as follows: Remove screw covers (if fitted) and handle retaining screws. [. . . ]