User manual ZANUSSI DW4803

[. . . ] DISHWASHER GESCHIRRSPÜLER DW 4803 152982 47/1 INSTRUCTION BOOKLET BEDIENUNGSANLEITUNG GB D Contents For the user Important safety information Description of the appliance The control panel Before use Setting the water softener Rinse aid Using your appliance Loading your appliance Use of detergent Hints and tips Washing programmes Operating sequence Maintenance and cleaning Internal cleaning Cleaning the filters External cleaning Prolonged periods of non-operation Frost precautions Moving the machine Something not working Service and spare parts Hints for test centres Technical specifications 3 4 4 5 5 7 8 8 10 11 12 13 14 14 14 15 15 15 15 16 17 18 18 For the installer Installation instructions Water supply connections Water outlet hose connection Electrical connection Adjusting the worktop Fitting under a counter Levelling 19 19 20 20 21 21 21 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions 1. Step by step Hints and tips Environmental information 2 IND31en Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. [. . . ] Follow the recommended quantity of detergent given in the "Washing programmes" chart. DE17 Min = 15 g Max = 30 g D If using detergent in tablets proceed as follows: 1. For all programmes; place 1 tablet inside the detergent dispenser. For all programmes with prewash; place a portion of a further tablet on the lid of the detergent dispenser. DE02 Insufficient quantities of detergent will produce poor washing results, whereas an excessive amount of detergent will not improve washing results and is also wasteful. Using no more than the correct amount also contributes to reducing pollution. Compact detergents with enzymes In these low-alkaline compact powders the environmentally unfriendly components have been replaced by natural enzymes and other more biodegradable substances. These new compact powders are generally phosphate-free. 10 M M IN AX DET03en Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see "Washing Programmes" chart) so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. The "On/Off" indicator light remains on until the On/Off push button is depressed. 2. Check that there is rinse aid and salt Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 10. Switch off the dishwasher 3. Switch off the dishwasher by pressing the On/Off push button and open the door. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. 5. 6. 7. Close the dishwasher door Set the programme Turn the programme selector dial clockwise until the programme marker on the knob corresponds with the programme you wish to select. Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 8. Start the programme Depress the On/Off push button. The "On/Off" indicator light will come on and the machine will start. If you wish to interrupt the washing programme at any time press this button again. 13 SEQ41/1en Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash without dishes using detergent. Cleaning the central filters (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards); the smaller filter (C) can be removed by pressing the two tongues (D). [. . . ] Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4" inch gas thread spout, or to a purpose made quick-coupling tap such as the Pressblock. CA17 19 COL04en Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. [. . . ]