User manual ZANUSSI DW66TCR

[. . . ] Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest Zanussi Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List or by looking in the telephone directory, under Zanussi. Our Zanussi Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. To ensure that your dishwasher functions perfectly, Zanussi recommends using Calgonit System, a unique and complete product, tested by millions of householders. [. . . ] These new compact powders are generally phosphate-free. As phosphates have water softening properties, we suggest you add salt to the salt container even if the hardness of your water is as low as 4°dH (7°TH). This will avoid lime deposits on crockery and the inner tub. 32 M M IN AX PUD01GB Using your appliance Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. Do not load very small items which can fall through the baskets. Open the door and slide out the baskets to load the dishes. The lower basket The lower basket is designed to take saucepans, lids, plates (up to 27 cm in diameter), salad bowls, cutlery etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the upper spray arm can turn freely. UI33 IEC 436 / DIN 44990 The cutlery basket Long bladed knives stored in an upright position are a potential hazard. UI19 Long and/or sharp items of cutlery such as carvings knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Cutlery should be placed in the removable cutlery basket with the handles facing downwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together. Silver cutlery tends to go black if mixed with steel cutlery. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the basket back into the machine. 3. 10. At the end of the washing programme At the end of the washing programme the machine stops automatically. The On/Off indicator light remains on until the On/Off button is depressed. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart and close the lid. 11. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off button and open the door. When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. Caution Do not open the door during the hot phase: this may cause hot water escape. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 5. 6. Close the detergent dispenser lid Close the dishwasher door Set the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker. If necessary select the temperature of the main wash according to the instructions in the "Washing programmes" chart (see "Required pushbuttons"). 7. [. . . ] The locknut must be correctly fitted to avoid water leaks. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. [. . . ]