User manual ZANUSSI F802

[. . . ] WASHING MACHINE LAVE-LINGE F 802 INSTRUCTION BOOKLET NOTICE D'UTILISATION 132997350 GB F YOUR NEW WASHING MACHINE This new washing machine meets all requirements for a modern washing of laundry with reduced consumption of water, energy and detergent. I Environment protection I Packaging recycling The temperature selector dial allows you to choose personally the suitable washing temperature for your laundry. The automatic cooling of the washing water from 95°C to 60°C before draining will prevent plastic pipes of your drainage system from being deformed. The unbalance detection device prevents vibration during spinning. I I Materials marked with the symbol are recyclable. To enable them to be recycled, they must be placed in the appropriate collection areas (or containers). [. . . ] For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. 9 Maximum loads Recommended loads are indicated in the programme charts. General rules: cotton, linen: drum full but not too tightly packed ENGLISH Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load ­ the laundry is lightly soiled ­ large amounts of foam form during washing. Degrees of water hardness Degrees Level Characteristic German °dH French °T. H. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. [. . . ] Check that the filter in the inlet hose is not blocked. Refer to relevant paragraph in "water drainage" section. Check that the drain hose is not squashed or kinked. The spin suppression option has been selected. [. . . ]