User manual ZANUSSI FI4590T

[. . . ] Children should not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this product in any way. [. . . ] The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +18°C and +38°C. Cleaning the inside Before using, clean all inside parts with warm water and neutral soap to remove the typical new smell. Do not use abrasive detergent or powders as these can damage the finish. 4 Instructions for totally built-in appliances Dimensions of the recess Height of housing Depth of housing Width of housing mm 1225 mm 550 mm 560 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. 3 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For appropriate venting, follow indications in Fig. 1 C D455 Press in the joint covers between the appliance and the kitchen furniture. cm 2 200 D028 Push appliance into the housing until stop strip (A) touches the kitchen unit. 2 A D456 Apply covers (B) on joint cover lugs and into hinge holes. 5 D022 B D110 5 Position the two runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 6 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. 6 H Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). [. . . ] If the light does not go on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. 13 Periodic cleaning Clean the inside with warm water and bicarbonate of soda. Periods of non-use If you are not using the appliance for any length of time, the following precautions should be taken: unplug the appliance; take all food out; defrost and clean the inside and all the accessories; leave the door ajar so that air can circulate inside in order to prevent unpleasant smells forming. D025 SERVICING If a fault occurs, check the following before calling the Servicing Department: The light does not come on when you open the door. [. . . ]