User manual ZANUSSI FJS902W

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. [. . . ] 12 LAUNDRY BLEACH For additional stain removal you may wish to use a product such as Ace Gentle Bleach which is used in addition to your chosen detergent. Ace is suitable for all washable fabrics including silks, woollens and coloureds. Wash Care Symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labelling code is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correct programme on your washing machine. WASHING SYMBOL 95 WASH ACTION Normal (Maximum) Normal (Maximum) FABRIC White Cotton or Linen without Special Finishes Cotton, Linen or Viscose without Special Finishes Colourfast at 60°C. Nylon, Polyester/Cotton, Viscose with Special Finishes, Cotton, Linen or Viscose Colourfast at 40°C but not 60°C. Acrylics, Acetate, Triacetate, Wool mixes, Polyester/wool blends. Wool, wool mixtures, Silks Do not machine wash 60 50 Reduced (Medium) Normal (Maximum) Reduced (Medium) Much Reduced (Minimum) Hand wash only 40 40 40 BLEACHING Chlorine bleach may be used IRONING Hot iron Warm iron Cool iron DRY CLEANING Cotten, Linen, Viscose Polyester mixtures, Wool Acrylic, Nylon, Polyester P TUMBLE DRYING May be dry cleaned. Other letters and/or a bar beneath the circle will indicate the required process to the dry cleaner. May be tumble dried with high heat setting with low heat setting X A cross through any symbol means «DO NOT» fabric conditioner to avoid the conditioner entering the machine prematurely. When using liquid detergent and a prewash programme, place the detergent into the correct compartment in the dispenser drawer, after the prewash has finished. 13 Important Notes For best results, always use the dispenser drawer for dispensing detergents and liquid additives. Once the dispenser has been filled, close it by pushing it in gently. The water should drain by gravity into the bowl. When the bowl is full, hook the hose back up and empty the bowl. Repeat the procedure until water stops flowing out. Clean carefully under a fast running tap. P0011 P0132 Warning When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it. P0133 P0040 The water inlet filters If your water is very hard or contains traces of lime deposit, the water inlet filters may become clogged. It is therefore a good idea to clean them from time to time. Remove and clean the filters using a hard bristle brush. Replace the filters and tighten up the inlet hoses. P0041 The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. n Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hoses in a bowl. n Screw the inlet hoses and reposition the drain hose. [. . . ] If you intend the drain hose to empty into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic "U-Piece" supplied. P0022 Important Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Levelling Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level. Any necessary adjustment can be made with a spanner. [. . . ]