User manual ZANUSSI FJS974N

[. . . ] WASHING MACHINES FJS 974 N FJS 1084 124976480 INSTRUCTION BOOKLET YOUR NEW WASHING MACHINE This new washing machine, which is fitted with the Jet System, patented Zanussi, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed. s Environment protection s Packaging recycling The temperature selector dial allows you to choose personally the suitable washing temperature for your laundry. The special wool programme with its new delicate wash system treats your woollen with extreme gentleness. The automatic cooling of the washing water from 95°C to 60°C before draining will prevent plastic pipes of your drainage system from being deformed. [. . . ] Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Before loading the laundry Never wash whites and coloureds together. Whites may lose their "whiteness" in the wash. New coloured items may run in the first wash; they should therefore be washed separately the first time. Make sure that no metal objects are left in the laundry (e. g. Button up pillowcases, close zip fasteners, hooks and poppers. Remove persistent stains before washing. Rub particularly soiled areas with a special detergent or detergent paste. Remove hooks or tie them up in a bag or net. Maximum loads Recommended loads are indicated in the programme charts. General rules: cotton, linen: drum full but not too tightly packed synthetics: drum no more than half full 10 Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load ­ the laundry is lightly soiled ­ large amounts of foam form during washing. Degrees of water hardness Degrees Level Characteristic German °dH 00-07 08-14 French °T. H. 00-15 16-25 Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. [. . . ] Too much detergent or unsuitable detergent (creates too much foam) has been used. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. Check that the drain hose is not damaged. [. . . ]