User manual ZANUSSI FL1012

[. . . ] . Washing 4. 5 kg of white cotton at 95°C . Washing 2 kg of synthetic fabrics at 40°C Maintenance and cleaning . . Descaling, after each wash, external cleaning . Cleaning the dispenser drawer, cleaning the drawer recess, the dangers of freezing Cleaning the filter . [. . . ] Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red. The plug moulded on to the lead incorporates a fuse. For replacement, use a 13 Amp BS1362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Zanussi Service Centre whose address can be found in the Customer Care Leaflet accompanying this manual. 6 GETTING TO KNOW YOUR MACHINE Control panel '' WASH COTTON / LINENS MIXED FABRICS DELICATES /SYNTHETICS '' RINSE SPECIAL PROGRAMMES HALF LOAD RINSE HOLD 450 rpm ECONOMY NORMAL NON-FAST WHITES & COLOUREDS COLOUREDS D J J C G J FRESHEN UP HAND RINSES M L F N SPIN SPIN (800 rpm) SPIN (600 rpm) PREWASH + BOILWASH WOOL WORN ONCE DRAIN A B H K P ON - OFF QUICK WASH IMPORTANT PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE SUPER WASH FL 850 1 2 3 4 5 6 7 8 1 Detergent dispenser drawer Symbols Prewash Wash Fabric softener 5 Economy button By depressing this button prior to selecting wash programmes B, C and G you will obtain a reduction of the wash temperature from 95°C to 60°C and from 50°/60°C to 40°C . The duration of the programme will not alter. Weigh the laundry the first few times you use the appliance. The average weights of the most common items are listed below as a guide: s Some stains such as fruit, wine, grass, rust etc. are difficult to remove and should be treated before washing with specific products, which can be found in most household shops. Cotton, Linen or Viscose Colourfast at 40°C but not 60°C. Acrylics, Acetate, Triacetate, Wool mixes, Polyester/wool blends. Wool, wool mixtures, Silks Do not machine wash 60 Normal (Maximum) 50 Reduced (Medium) Normal (Maximum) Reduced (Medium) Much Reduced (Minimum) Hand wash only 40 40 40 BLEACHING Chlorine bleach may be used IRONING Hot iron Warm iron Cool iron DRY CLEANING Cotten, Linen, Viscose Polyester mixtures, Wool Acrylic, Nylon, Polyester P TUMBLE DRYING May be dry cleaned. Other letters and/or a bar beneath the circle will indicate the required process to the dry cleaner. May be tumble dried with high heat setting with low heat setting X IMPORTANT NOTES A cross through any symbol means «DO NOT» For best results, always use the dispenser drawer for dispensing detergents and liquid additives. Once the dispenser has been filled, close it by pushing it in gently. This is particularly important if you are using fabric conditioner to avoid the conditioner entering the machine prematurely. When using liquid detergent and a prewash programme, place the detergent into the correct compartment in the dispenser drawer, after the prewash has finished. 9 Programmes for cotton and linen Recommended load: max. 4. 5 kg (10 lb) Compartments to use ( if required) Programmes Degree of soil Programme dial position Description PREWASH & BOILWASH Heavy A B C D F Prewash at 40°C Wash at 95 °C 4 rinses Spin Wash at 95 °C 4 rinses Spin Wash at 60 °C 4 rinses Spin Wash at 40 °C 4 rinses Spin BOILWASH Normal WHITES (·) & FAST COLOUREDS NON-FAST COLOUREDS Normal Light SPIN 800 or 1000 Spin at: 800 rpm (FL850-FL850AL) 1000 rpm (FL1085-FL1012) Water filling: 30°/40° programmes: cold water filling 50°/60° programmes: hot and cold filling Water filling: 95° programmes: hot filling (·) This 60° programme is the reference programme for the Energy label according to the article 2, paragraph 1 of the EEC Directive 92/75. Quick'n'Clean Dial Anticlockwise Quick wash LESS 16-24 (*) MINUTES LESS 8-12 (*) MINUTES Step 3 Step 2 Clockwise Step 2 DIAL POSITION Step 1 Normal wash Step 1 Increases wash time in equal increments Programme ABC&G Super wash PLUS 12-18 (*) MINUTES PLUS 6-9 (*) MINUTES D Decreases wash time in equal increments (*) The wash times will vary dependent the incoming water temperature and pressure. For example if your appliance is connected to cold water only, or the incoming hot water is below 40°C, the wash time will be increased. To obtain a normal wash the dial should be positioned off centre as shown in the diagram of the control panel on page 7. 10 Programmes for synthetics, delicates and wool Recommended load: max. 1 kg (2. 2 lb) Compartments to use ( if required) Programmes Degree of soil Programme dial position Description MIXED FABRICS Normal G H J K L M N P Wash at 50 °C 3 rinses Short spin (*) Wash at 40 °C 3 rinses Short spin (*) Wash at 40 °C 3 rinses Short spin (*) Wash at 30 °C 3 rinses Short spin (*) WOOL WASH Normal DELICATES/ SYNTHETICS Normal 30 WORN ONCE Light HAND RINSES 3 rinses, with fabric softener, if required Short spin (*) 1 rinse, with fabric softener, if required Short spin (*) Draining of water and short spin at 600 rpm FRESHEN UP SPIN 600 DRAIN Draining of water (*) if the RINSE HOLD button has not been depressed 11 USE OF DETERGENT AND ADDITIVES Which detergent? To ensure you obtain the best wash results from your appliance, it is important to use the right detergent in your everyday wash, and only detergents recommended for use in automatic machines. [. . . ] Remove and clean the filters using a hard bristle brush. Replace the filters and tighten up the inlet hoses. P0041 P0132 P0133 Clean carefully under a fast running tap. P0040 Warning When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it. 16 SERVICING Before contacting your local ZANUSSI Service Centre, please make the following checks: The machine does not start up s s The door does not open s s The safety device has locked it Water in the tub: the door cannot be opened if water is present in the tub s The door is not closed properly No water is entering the machine (see: the machine does not fill) The selector dial is not correctly positioned and pulled out The machine does not fill s s s s s s If after the above checks, there is still a fault, call your local Zanussi Service Force Centre. [. . . ]