User manual ZANUSSI FL1014V

[. . . ] Use a programme with prewash only for heavy soiled items. Measure out detergent according to the water hardness, degree of soiling and quantity of laundry being washed. s When the appliance is to be scrapped, cut off the power supply cable and make the door closing device inoperative to avoid it becoming a death trap for a child. For correct disposal of the machine, contact your local authority department which provides for collection of urban solid refuse. s The symbols you will see on some paragraphs of this booklet have the following meaning: Important information concerning the safety in the use of your machine. Disregarding this information might lead to damages. i Information for correct use of your machine and to obtain the best performance. [. . . ] 10) Remove the door catch (7) and plate (8) as explained in paragraph 7. 12) Refit the door catch (7) and plate (8), reversing their position and pressing firmly to engage the hook (Fig. 13) Fit the door onto the washing machine. Insert the top pin first, then the bottom pin into the hinge (3- Fig. B); finally screw the hinge onto the washing machine. 14) Check that the door is aligned with the appliance. B) by a couple of turns and re-tighten when alignment is correct. 15) Fit the flexible end of the door catch (1 - Fig. B) into the location provided in the door. 6 7 2 5 8 1 93 4 A P0534 1 5 6 7 2 4 39 8 B P0535 Fitting a door panel The door of this washing machine has mouldings to allow fitting of a decorative panel (stainless steel sheet, laminated plastic, wood etc. ) to match with the existing kitchen units. The dimensions of the panel must be as follows: Width 588 mm Height 588 mm Maximum thickness 004 mm To fit the panel, remove the moulding by unscrewing its fixing screws. Position the panel, then refit the moulding, making sure that it comes into contact with and firmly clamps the panel. 28 USE Control panel Blancos Colores Colores delicados Sintéticos Delicados Lana B B C K L M 60º- 90º 40º- 60º 30º- 40º 30º- 60º 30º- 40º 30º- 40º Blancos con prelav. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load ­ the laundry is lightly soiled ­ large amounts of foam form during washing. Degrees of water hardness Degrees Level Characteristic German °dH French °T. H. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. All commonly available washing machine detergents may be used in this appliance: ­ powder detergents for all types of fabric, ­ powder detergents for delicate fabrics (60°C max) and woollens, ­ liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only. The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. If using concentrated powder or liquid detergents, a programme without prewash must be selected. Pour liquid detergent into the dispenser drawer compartment marked just before starting the programme. [. . . ] Check that the inlet hose is not squashed or kinked. Check that the filter in the inlet hose is not blocked. Refer to relevant paragraph in "water drainage" section. Check that the drain hose is not squashed or kinked. [. . . ]