User manual ZANUSSI FL1030-A

[. . . ] Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest ZANUSSI Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List. Our ZANUSSI Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. This new washing machine meets all requirements for a modern washing of laundry with reduced consumption of water, energy and detergent. s The temperature selector dial allows you to choose personally the suitable washing temperature for your laundry. The automatic cooling of the washing water from 90°C to 60°C before draining will prevent plastic pipes of your drainage system from being deformed. s Ecological hints In order to obtain water and energy savings and to protect the environment, we advice you to follow these instructions: s Always wash full loads for maximum savings. [. . . ] A) and fit them on the opposite side (4 - Fig. A) by inserting a screwdriver into the upper hole and pushing downwards. 8) Remove plate (6) by inserting a screwdriver into the bottom hole and pushing upwards (Fig. 9) Refit the catch hook (5) and plate (6) on the opposite sides (Fig. 10) Remove the door catch (7) and plate (8) as explained in paragraph 7. 12) Refit the door catch (7) and plate (8), reversing their position and pressing firmly to engage the hook (Fig. 13) Fit the door onto the washing machine. Insert the top pin first, then the bottom pin into the hinge (3- Fig. B); finally screw the hinge onto the washing machine. 14) Check that the door is aligned with the appliance. B) by a couple of turns and re-tighten when alignment is correct. Button up pillowcases, close zip fasteners, hooks and poppers. Remove persistent stains before washing. Rub particularly soiled areas with a special detergent or detergent paste. Remove hooks or tie them up in a bag or net. Maximum loads Recommended loads are indicated in the programme charts. General rules: cotton, linen: drum full but not too tightly packed synthetics: drum no more than half full ENGLISH Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. [. . . ] s Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme until the selector dial is in the "Stop" position. s Screw the inlet hose and reposition the drain hose. s When you intend to start the machine up again, make sure that the room temperature is above 0°C. 37 ENGLISH Pull out the filter. [. . . ]