User manual ZANUSSI FL1030/B

[. . . ] Hydraulic connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Levelling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Descriptions of the controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] s Always unplug the appliance and turn off the water after use. s Leave the porthole slightly ajar between washes to preserve the door seal. s All packing and transit bolts must be removed before use. s Serious damage can occur to the product and to property if this has not been adhered to. See relevant section (unpacking) in the instruction booklet. s The washing machine must be unplugged when removing the interior transit bolts. Do not plug the appliance before finishing the removal of the transit bolts and the fixing of the caps in the holes where the security bolts were. s If the appliance is to stand on a carpeted floor make sure that there is space between the carpet and the supporting feet of the appliance for the air to circulate freely around . s Care must be taken to ensure that the appliance does not stand on the electrical supply cable. 3 ENGLISH UNPACKING AND INSTALLATION TRANSIT SECURITY BARS Before starting the machine up, the transport security bars must be removed as follows: You are advised to keep all the transport security bars in case the appliance has to be transported again. Unscrew and remove the three rear screws by means of a key. HYDRAULIC CONNECTION There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3/4 gas for the water supply, a sink, a wash basin or a drainage system in the wall. Previously check if: -- -- it is not a hot water tap. The manufacturer declines any liability in case of accidents or incidents should these safety measures not be observed. (Never touch the washing machine or any electric appliance while standing on a wet floor or being barefoot. ) LEVELLING Level the appliance by loosening or tightening the feet. Once in the right position fix the feet by pushing the nuts against the base of the case. Accurate levelling will prevent vibration, noise and displacement of the appliance during operation. Do not overload the washing machine, but always try to use its utmost capacity in accordance with the type of fabric. Reduce the quantity when washing very dirty or fluffy laundry . Once the machine is working and you wish to add any item you must stop the program. IMPORTANT REMARK: This appliance is provided with a security device to avoid opening during the cycles. Open it only when absolutely necessary and wait 2 to 3 minutes after you have stopped the machine to give the safety device time to unlock. 4. SELECT THE TEMPERATURE Turn the dial clockwise to the desired temperature . 5. SELECT THE PROGRAM Turn the dial clockwise until the marker reaches the desired program. 6. [. . . ] If one of the labels is marked 30°C, select 30°C for the whole cycle. TABLE OF SYMBOLS The symbols on the labels are of great help for the wash, care and treatment. 30°C Hand wash DELICATE WASH Do not wash at all BLEACHING Bleach in cold water Do not bleach IRONING Hot iron max. 100°C Do not iron DRY CLEANING Dry cleaning in all solvents Dry cleaning in perchlorethylene, petrol, pure alcohol, R 111 y R 113 Dry cleaning in petrol, pure alcohol, R 111 y R 113 Do not dry cleaning High temperature Low temperature DRYING Flat On the line On clothes hanger Tumble dry Do not tumble dry 9 ENGLISH MAINTENANCE AND CLEANING Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. THE DANGERS OF FREEZING If the machine is exposed to temperatures below 0ºC, certain precautions should be taken. * Turn off the water tap and unscrew the inlet hose. [. . . ]