User manual ZANUSSI FL1084

[. . . ] Fuzzy Logic technology enables the washing time in the White cotton and Coloured cotton programmes to be calculated automatically according to the weight of the laundry. Automatic cooling of the wash water to 60°C before draining, with the 95°C programme, prevents distortion of plastic pipes in the domestic water system due to the high temperature of the water. The special wool programme with its new delicate wash system treats your woollen with extreme gentleness. The anti-unbalance device ensures that the washing machine remains stable when spinning. In the interest of the environment s s s s Materials marked with the symbol are recyclable. [. . . ] Select the EXTRA RINSE option if required EX TRA RINSE SOAK RINSES SPIN DRAIN SPECIAL PROG RAMMES 10. Select the DELAY START option, if required Before starting the programme, if you wish to delay starting, press the DELAY START button to set the required delay, which appears in the display. Then press the START/PAUSE button: the machine starts its countdown. FINISH TIME TO DEL AY START 12 E R 11. Start the programme To start the selected programme, press the START/PAUSE button; the display stops flashing and the door pilot light comes on to indicate that the door locking device is engaged. The programme starts after about 30 seconds. RT/ PAUSE STA 1 2 3 4 12. Store the programme The wash programme selected can now be stored by pressing one of the MEMORY buttons until the corresponding pilot light comes on. MEMORY 13. At the end of the programme The machine stops automatically and three flashing zeros are displayed. The programme which has just been completed is still in the memory and the corresponding pilot lights stay on. If the RINSE HOLD option has been selected, the corresponding pilot light flashes to indicate that the water must be emptied out before opening the door. The machine is fitted with a safety device that prevents opening of the door for about 2-3 minutes after the end of the programme. The door can only be opened after the door locked light has gone out. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Maximum loads Recommended loads are indicated in the programme charts. General rules: cotton, linen: drum full but not too tightly packed synthetics: drum no more than half full delicate fabrics and woollens: drum no more than one third full Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. 14 Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. [. . . ] Pull out the three plastic spacers from the holes into which the bolts were fitted. Plug the open holes with the plugs which you will find at the back of the appliance. P0256 P0020 Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. [. . . ]