User manual ZANUSSI FL1282

[. . . ] Tips and information about economical and ecological use of the machine are marked with this symbol. Our contribution to the protection of the environment: we use environmentally friendly paper. 2 Contents Warnings Disposal 4-5 5 Maintenance Door seal Bodywork Detergent dispenser drawer Drain filter Water inlet filter Emergency emptying out Frost precautions 24 24 24 24 24 25 25 25 Tips for environmental protection 5 Technical specifications Installation Unpacking Positioning Water inlet Water drainage Electrical connection 6 7 7 7 7 8 8 Something not working? 26-27 Your new washing machine Description of the appliance Door locked pilot light Detergent dispenser drawer 9 9 9 9 Use Control panel Controls Washing hints Sorting the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives International wash code symbols Operating sequence Washing programmes Special programmes 10 10 10-15 16 16 16 16 16 16 16 17 18 19-21 22 23 3 ENGLISH Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation · All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book. [. . . ] The end of the programme is shown on the display with a blinking zero. Delayed start The delayed start that was set with the button (10) is shown on the display (max 24 hours). Alarm code In case of breakdowns of the appliance, these are indicated on the display with a special code, very useful for the user and for the technical assistance, e. g. "E20" (see page 26). 9 "START/PAUSE" button This button has 3 functions: Start ­ Pause ­ Drain U RT/ PA SE STA The delay time value will decrease by one unit every hour. Incorrect option selection If an option which is not compatible with the set wash programme is selected, the message Err is displayed. Start Pressing this button the selected programme is started. If the delayed start has been set, the countdown will start. Now on the display the duration of the programme or the hours of the delayed start are blinking. Pause Pressing this button a programme already started can be interrupted in any moment; pressing again the button, the programme restarts. During the pause, the indication on the display is blinking. This is also indicated by three sound signals and by the corresponding lights that blink for about 2 seconds. 14 Drain Pressing this button: · the water of the programme "SOAK" is drained, · the water in the programmes with "RINSE HOLD" option is drained and a final spin is carried out. How to open the door 1. With the machine switched off With power supply switched off (with the machine off) it is possible to open the door in any moment. How to open the door during a programme 10 DELAY START button With this button it is possible to delay the starting of the programme by up to 24 hours max. The door can be opened also during a programme provided the following conditions exist: · The temperature of the water must be lower than 40°C. · The level of the water must be low · There must not be a spin in progress. E TOFINISH TIM Y DELA START Press the START/PAUSE button. Remove hooks or tie them up in a bag or net. Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. [. . . ] · The DELAY START option has been selected. · · · · The water tap is closed. (E10) The inlet hose is squashed or kinked. (E10) The filter in the inlet hose is blocked. [. . . ]