User manual ZANUSSI FL622C

[. . . ] Use a programme with prewash only for heavy soiled items. Measure out detergent according to the water hardness, degree of soiling and quantity of laundry being washed. Use a short programme when washing lightly soiled laundry. s s s The symbols you will see on some paragraphs of this booklet have the following meaning: Important information concerning the safety in the use of your machine. Disregarding this information might lead to damages. i Information for correct use of your machine and to obtain the best performance. [. . . ] The end of the drain hose must always be ventilated, i. e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. Run it along the floor; only the part near the drainage point must be raised. P0023 Electrical connection This machine is designed to operate on a 220230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2. 2 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution. 26 USE Control panel Blancos Colores resistentes Colores delicados Sintticos Delicados Lana B 60- 90 B 40- 60 C 30- 40 K 30- 60 L 30- 40 M 30- 40 Blancos con prelavado Sintticos con prelavado Lavado rpido Aclarados Suavizantes Centrifugado Descarga A J D F G H 60- 90 30- 60 30- 40 N P Q R 1 2345 6 7 8 1 Detergent dispenser drawer 2 No spin button Depress this button when you have to wash particularly delicate cotton or linen items in order to exclude all the spinning phases. 5 START/STOP button Press this button to start the machine: the pilot light will come on. The same button is used to switch the machine off. Before selecting a programme or changing an ongoing programme the machine must be switched off by depressing the same button. 3 Half load button Select this button to reduce water consumption on the rinse cycle when washing a smaller load of cottons or linens (max. The machine will carry out 3 rinses instead of 4. 6 Temperature selector dial Turn this dial to select the washing temperature. Depress the dial to pop it out. 4 Rinse hold button Press this button to make the machine stop with water in the drum after the synthetic or delicate wash cycles. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Energetic programmes for cotton and linen Maximum load: 4. 5 kg Progr. Temp. Type of laundry Whites with prewash (heavy soiled) Whites without prewash (normally soiled) Fast coloureds without prewash (normally soiled) Cycle description Prewash Wash at 60-90C 4 rinses Long spin Wash at 60-90C 4 rinses Long spin Wash at 40-60C 4 rinses Long spin Wash at 30-40C 4 rinses Long spin Wash at 30-40C 4 rinses Long spin 4 rinses with liquid additives, if required Long spin 1 rinse with liquid additive, if required Long spin Possible options A B 60-90 60-90 B() 40-60 C D F G H 30-40 No fast coloureds (normally soiled) 30-40 Quick wash lighty soiled laundry Rinses Softener Spin Drain and long spin The temperatures indicated are the optimum temperatures for each programme and depend on the type of laundry and degree of soiling. () This programme at 60C is the reference programme for the Energy label according to the EEC Directive 92/75: water 72 litres energy 1. 3 kWh time 130 mins 30 Gentle programmes for synthetics, mixed fibres, delicates and woollens Maximum load: 2 kg, woollens: 1kg Progr. Temp. Type of laundry Synthetics with prewash (heavy soiled) Synthetics without prewash (normally soiled) Cycle description Prewash Wash at 30-60C 3 rinses Short spin Wash at 30-60C 3 rinses Short spin Wash at 30-40C 3 rinses Short spin Wash at 30-40C 3 rinses Short spin J K L M N P Q R 30-60 30-60 30-40 Delicate fabrics - Silk 30-40 Woollens ( ) Rinses 3 rinses with fabric softener Short spin Softener 1 rinse with fabric softener Short spin Spin Drain and short spin Drain Draining of water The temperatures indicated are the optimum temperatures for each programme and depend on the type of laundry and degree of soiling. 31 ENGLISH Possible option Operating sequence Before washing your first load of laundry, we recommend that you run a cotton cycle at 60C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine. 1. Place the laundry in the drum Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Measure out the detergent Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out a prewash, pour detergent into the appropriate compartment marked . 3. Measure out the additives If required, pour fabric softener into the compartment marked and the bleaching agent into the compartment marked without exceeding the MAX mark. P0444 P0445 4. Select the temperature Turn the selector dial to the required temperature setting. 90 P0450 32 6. Select the programme and start it Turn the programme selector dial clockwise to the required wash programme and press the start/stop button : the operating pilot light comes on and the machine starts to operate. B P0465 P0471 7. [. . . ] Check that the inlet hose is not squashed or kinked. Check that the filter in the inlet hose is not blocked. Refer to relevant paragraph in "water drainage" section. Check that the drain hose is not squashed or kinked. [. . . ]