User manual ZANUSSI FLD884V

[. . . ] Tips and information about economical and ecological use of the machine are marked with this symbol. Our contribution to the protection of the environment: we use recycled paper. 23 ENGLISH Contents Warnings Disposal 25-26 26 Maintenance Bodywork Detergent dispenser drawer Drain filter Water inlet filter Emergency emptying out Frost precautions 40 40 40 40 40 41 41 Tips for environmental protection 26 Technical specifications Installation Unpacking Positioning Water inlet Water drainage Electrical connection Door reversal 27 28 28 28 28 29 29 30 Something not working? 42-43 Your new washing machine Description of the appliance Detergent dispenser drawer 31 31 31 Use Control panel Controls Washing hints Sorting the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives International wash code symbols Operating sequence Washing programmes 32 32 32 33 33 33 33 33 33 33 34 35 36-37 38-39 24 Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation · All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book. [. . . ] 15) Fit the flexible end of the door opening stop into the location provided in the door (1 - Fig. B). 6 7 2 5 8 1 93 1 5 6 4 A P0534 7 2 4 39 8 B P0535 Fitting a door panel The door of this washing machine has mouldings to allow fitting of a decorative panel (stainless steel sheet, laminated plastic, wood, etc. ) to match with the existing kitchen units. The dimensions of the panel must be as follows: Width Height Maximum thickness 588 mm 588 mm 004 mm To fit the panel, remove the moulding by unscrewing its fixing screws. Position the panel, then refit the moulding, making sure that it comes into contact with and firmly clamps the panel. 30 Your new washing machine This new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. · The temperature selector dial will allow you to choose the most suitable temperature for your laundry. · The automatic cooling of the washing water from 90° to 60°C before draining will prevent old drain pipes from being deformed. Description of the appliance 1 Detergent dispenser drawer 2 Programme chart 3 Control panel 4 Door handle 5 Drain filter 6 Adjustable feet 4 4 2 2 1 3 1 3 5 5 6 6 Detergent dispenser drawer Prewash Main wash Fabric softener, starch Bleaching agent Cl P0446 31 ENGLISH · The balance control device ensures the machine is stable during the spin. Use Control panel Blancos Colores resistentes Colores delicados Sintéticos Delicados Lana B B C K L M 60º- 90º 40º- 60º 30º- 40º 30º- 60º 30º- 40º 30º- 40º Blancos con prelav. Lavado rápido Aclarados Suavizantes Centrifugado Descarga 60º- 90º A 30º- 60º J 30º- 40º D FN GP HQ R FLD 600 1 234 5 6 7 8 Blancos Colores resistentes Colores delicados Sintéticos Delicados Lana B B C K L M 60º- 90º 40º- 60º 30º- 40º 30º- 60º 30º- 40º 30º- 40º Blancos con prelav. Lavado rápido Aclarados Suavizantes Centrifugado Descarga 60º- 90º A 30º- 60º J 30º- 40º D FN GP HQ R FLD 800 1 234 5 6 7 8 1 Programme chart It will help you to choose the most suitable washing programme for your laundry. 5 On/Off button Press this button to start the machine. The same button is used to switch the machine off. Before selecting a programme or changing an ongoing programme the machine must be switched off by depressing the On/Off button. 2 Spin speed reduction button By depressing this button the spin speed is reduced as follows: q cotton and linen: from 600/800 rpm according to the model to 400 rpm q synthetics, delicates and wool: from 750 to 400 rpm for FLD 800-FLD 800 M and from 550 rpm to 400 rpm for FLD 600. 6 Temperature selector dial (thermostat) To select the washing temperature turn the dial to the required value. (FLD 800-FLD 800 M) When your laundry is only lightly soiled, a cold wash can be used (dial to position ). 3 Intensive rinse button By depressing this button on programmes for cotton and linen the machine will perform the rinses with high water level. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load, ­ the laundry is lightly soiled, ­ large amounts of foam form during washing. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. All commonly available washing machine detergents may be used in this appliance: ­ powder detergents for all types of fabric, ­ powder detergents for delicate fabrics (60°C max) and woollens, ­ liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only. The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. If using concentrated powder or liquid detergents, a programme without prewash must be selected. [. . . ] · The ON/OFF button has not been depressed. · The machine does not fill: · The water tap is closed. · The inlet hose is squashed or kinked. · The filter in the inlet hose is blocked. · The door is not properly closed. · The machine fills then empties immediately: · The machine does not empty and/or does not spin: · The end of the drain hose is too low. [. . . ]