User manual ZANUSSI FLS572C

[. . . ] WASHING MACHINE PRALKA AUTOMATYCZNA AUTOMATA MOSÓGÉP AUTOMATICKÉ PRACKY AUTOMATICKÁ PRÁCKA FLS 572 C FLS - BOMULD OG LINNED 1 30º-90º KOGEVASK MED FORVASK 2 30º-90º KOGEVASK UDEN FORVASK 2 30º-60º KULØRTVASK 3 30º-40º KULØRTVASK SKYLNINGER 4 SKYLLEMIDDEL 5 CENTRIFUGERING 6 SYNTETISK VASK, FINVASK OG 7 30º-60º SYNTETISK VASK MED FORVASK 8 30º-60º SYNTETISK VASK UDEN FORVASK 9 30º-40º FINVASK ULD SKYLNINGER 40º SKILLEMIDDEL 1 TØMNING 0 1 1 2 3 13 12 11 10 9 30° 4 5 87 6 90° 80 ° 70° INSTRUCTION BOOKLET INSTRUKCJA OBSLUGI HASZNÁLATI ÚTMUTATÓ NÁVOD K OBSLUZE NÁVOD NA OBSLUHU 35. 292. 471/2 60° 50° 40 ° CONTENTS Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Unpacking and installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Transit security bars. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Previously check if: -- -- it is not a hot water tap. If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Have the permanent drainage system in the wall checked by a plumber. Place the enclosed rubber joint, delivered in a plastic bag together with the appliance (A), at the very end of the inlet hose and carefully screw the pipe to the tap taking care not to damage the screwdrive and fix the nut well on to the end in order to avoid leaking. If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance. 2. Lean the appliance back on the rear and fit one of the polystyrene angles between the appliance and the floor. Make sure the hoses are not squashed. 3. Carefully remove the plastic bags on the right and the left, pulling them to the centre of the appliance. Now tighten the nut anew to avoid leaks. (Open the tap and asure that it does not leak and close it again. ) Place the discharging hose in a washbasin or sink with the aid of the bent piece delivered separately. Wooden floors are particularly susceptible to vibrations. If posible always place the appliance on a solid floor. 60 cm. Maximun DESCRIPTION OF THE CONTROLS Control panel 1 2 3 4 5 6 1. WASHING POWDER DISPENSER The dispenser is provided with 3 compartments marked with the following symbols: 4. "NO SPINNING" BUTTON Pressing this button before starting the intense washing program all spinnings will be excluded. The other steps of the program remain unchanged. 5. TEMPERATURE SELECTOR This control allows you to select the temperature of the washing cycle in accordance with the kind of clothes to be washed. Turn the control until the required temperature coincides with the marker. «Prewash» symbol shows the compartment for the prewash detergent. «Wash» symbol shows the compartment for the washing detergent. «smooth» symbol shows the compartment for the smoothing additives. On the program table you will find the most appropriate temperature for each kind of washing. Selecting F any program can be run through with cold water. This will ensure a saving in electricity consumption. 6. PROGRAM SELECTOR To select the required program turn the control clockwise until the marker on the top coincides with the number of the required program (reference mark on the control panel). If at any chance you pass by the required number NEVER TURN THE CONTROL ANTICLOCKWISE just continue clockwise until the required number is reached again. 2. [. . . ] * Select a wash program and run for a few seconds. * Position the end of the drain hose in a bowl on the floor. * Run the draining program for a few seconds. This way you make sure no water at all remains in the appliance which could freeze and thus damage it and its surroundings. [. . . ]