User manual ZANUSSI FLS873C

[. . . ] WASHING MACHINE PRALKA AUTOMATYCZNA AUTOMATICKÉ PRACKY AUTOMATA MOSÓGÉP AUTOMATICKÁ PRÁCKA FLS 873 C FLS - BOMULD OG LINNED 1 30º-90º KOGEVASK MED FORVASK 2 30º-90º KOGEVASK UDEN FORVASK 2 30º-60º KULØRTVASK 3 30º-40º KULØRTVASK SKYLNINGER 4 SKYLLEMIDDEL 5 CENTRIFUGERING 6 SYNTETISK VASK, FINVASK OG 7 30º-60º SYNTETISK VASK MED FORVASK 8 30º-60º SYNTETISK VASK UDEN FORVASK 9 30º-40º FINVASK ULD SKYLNINGER 40º SKILLEMIDDEL 1 TØMNING 0 1 1 2 3 13 12 11 10 9 30° 4 5 87 6 90° 80 ° 70° INSTRUCTION BOOKLET INSTRUKCJA OBSLUGI NÁVOD K OBSLUZE HASZNÁLATI ÚTMUTATÓ NÁVOD NA OBSLUHU 35. 292. 462/2 60° 50° 40 ° CONTENTS Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Unpacking and installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Transit security bars. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Have the permanent drainage system in the wall checked by a plumber. Place the enclosed rubber joint, delivered in a plastic bag together with the appliance (A), at the very end of the inlet hose and carefully screw the pipe to the tap taking care not to damage the screwdrive and fix the nut well on to the end in order to avoid leaking. If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance. 2. Lean the appliance back on the rear and fit one of the polystyrene angles between the appliance and the floor. Make sure the hoses are not squashed. 3. Carefully remove the plastic bags on the right and the left, pulling them to the centre of the appliance. Now tighten the nut anew to avoid leaks. Accurate levelling will prevent vibration, noise and displacement of the appliance during operation. Some vibration is inevitable, especially if placed on a wooden floor. Wooden floors are particularly susceptible to vibrations. If posible always place the appliance on a solid floor. 60 cm. Maximun DESCRIPTION OF THE CONTROLS Control panel 1 2 3 4 5 6 7 1. WASHING POWDER DISPENSER The dispenser is provided with 3 compartments marked with the following symbols: 5. "800/550"BUTTON 550 If your washing machine is provided with this push button, press it to reduce the spinning speed from 800 to 550 r. p. m. 800 6. TEMPERATURE SELECTOR This control allows you to select the temperature of the washing cycle in accordance with the kind of clothes to be washed. Turn the control until the required temperature coincides with the marker. «Prewash» symbol shows the compartment for the prewash detergent. «Wash» symbol shows the compartment for the washing detergent. «smooth» symbol shows the compartment for the smoothing additives. On the program table you will find the most appropriate temperature for each kind of washing. Selecting F any program can be run through with cold water. This will ensure a saving in electricity consumption. 7. PROGRAM SELECTOR To select the required program turn the control clockwise until the marker on the top coincides with the number of the required program (reference mark on the control panel). If at any chance you pass by the required number NEVER TURN THE CONTROL ANTICLOCKWISE just continue clockwise until the required number is reached again. 2. ON/OFF LAMP It lights when the appliance is operating. 3. [. . . ] * Position the end of the drain hose in a bowl on the floor. * Run the draining program for a few seconds. This way you make sure no water at all remains in the appliance which could freeze and thus damage it and its surroundings. When you need to start the machine up again, make sure that the room temperature is above 0°C. EXTERNAL CLEANING Clean the exterior cabinet of the appliance with neutral soap and water only, and then dry thoroughly. CLEANING THE DISPENSER DRAWER AND THE RECESS Pull the drawer to remove (slightly at first till the stop, then pull hard). [. . . ]