User manual ZANUSSI IZZI ALU

[. . . ] DISHWASHER IZZI 152975 75/0 INSTRUCTION BOOK UK Contents Important safety information Description of the appliance The control panel Before use Setting the water softener Rinse aid Use of detergent Using your appliance Loading your appliance The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Hints and tips Washing programmes Operating sequence Maintenance and cleaning Something not working Service and Spare Parts Customer Care Department Guarantee Conditions Installation instructions Water supply connections Water outlet hose connection Electrical connection Fitting under a counter Levelling Hints for test centres 3 3 4 5 5 6 6 7 7 7 7 8 8 8 9 10 11 12 13 13 13 14 14 14 14 15 15 15 Technical specifications Dimensions Width Height with working top Height without working top Max depth Max depth with open door Voltage 60 85 82 63. 7 115. 2 cm cm cm cm cm Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure 220/240 V - 50 Hz 200 W 2100 W 2300 W 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Minimum Maximum Capacity This appliance complies with the following E. E. C. Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 2 Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. [. . . ] This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. enzymes, allows to achieve, with reduced conssumptions of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of the programme has been prolonged. ** Testing programme for EN 50242 (see "Hints for Test Centres"). This programme, developed for the use of detergents with *** Ideal for washing a complete load of 12 place settings with heavy soil. Characterised by a duration of about 80 minutes and a washing temperature of 70°C. The time value is approximate and depends on the pressure and the temperature of the water and also by the variations of the power supply. 9 Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 10. At the end of the washing programme The dishwasher will automatically stop and the indicator light of the programme turns off. Press the On/Off push button and open the door. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 2. Check that there is rinse aid and salt 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. Important!In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. 4. Ensure that the spray arms can rotate freely 5. Measure out detergent Add the required amount of detergent into the dispenser. Close the detergent dispenser lid. 6. Setting and starting the programme Press the On/Off push button: the On/Off and the "65° NORMAL" indicator light will illuminate. [. . . ] If the plug that is fitted to your appliance is not suitable for the socket, it must be cut off and the appropriate plug fitted. Important The wires on the mains lead are coloured in accordance with the following code: Green and Yellow - Earth - Neutral - Live Blue Brown Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it if necessary with a clip. Hooked over the edge of the sink using the special curved plastic guide provided. [. . . ]