User manual ZANUSSI TC470

[. . . ] @? INSTRUCTION BOOKLET TUMBLE DRYER TC470 CONTENTS Warnings . Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page 3 4 5 5 5 6 7 8 8 9 10 10 11 11 11 11 11 12 13 Your appliance . Electrical connections . Getting to know your machine Control panel Drying times Drying . . Maintenance and cleaning External cleaning . . . [. . . ] Fix door stopper «A» in hole «c» by 90° rotation. Hook door stopper «A» into hole «d». c A d F B C P0865 B 6 Electrical Connections WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off, and the appropriate plug fitted. The cut off plug should then be disposed of to prevent the hazard of electric shocks, in case it should be plugged into a 13 Amp socket in another part of your home. IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue - Neutral Brown - Live If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug. To fit the plug, proceed as follows: GREEN & YELLOW 13 AMP FUSE Avoid connecting the tumble dryer to the same socket as your washing machine (or any other appliance) by means of an adapter. Have an extra socket installed if necessary, by a qualified electrician. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. 13 AMP BROWN BLUE P0329 CORD CLAMP Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yellow. Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black. Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red. The plug moulded on to the lead incorporates a fuse. For replacement, use a 13 Amp BS1362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local ZANUSSI Service Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual. 7 GETTING TO KNOW YOUR MACHINE Control panel ZANUSSI DRYING TIME DOOR OPEN 1 1 Programme chart 2 Water Full Indicator Light (red) 2 3 4 5 4 Mains On Light (green) The pilot light indicates operating status. This light illuminates when the reservoir is full or improperly fitted. The programme will be interrupted. 5 On/OffDial - Time Selector Dial Turn the dial clockwise (to the right) to select the time for drying (see Chart page 9). At the same time the machine is switched on and the programme starts. This dryer has two drying cycles of up to 120 and 80 minutes, giving a high or low heat temperature according to the fabric type. [. . . ] Clean it with a brush and rinse it under the shower if necessary. P0636 P0639 Also clean the outside, removing all fluff. Clean the rubber seal round the porthole door and the seal of the condenser in the inner door with a damp cloth. 11 SERVICING Before contacting your local Zanussi Service Centre, please make the following checks: If, after the above checks, there is still a fault, call your local Zanussi Service Centre, whose address can be found in the accompanying Customer Care Booklet, and can also be found in your local telephone directory under «Z». Please make sure you give the model and serial number of the appliance. This information can be found on the rating plate or on the guarantee certificate. [. . . ]