User manual ZANUSSI TCS6550E

[. . . ] TUMBLE DRYER SECADORA SECADOR TCS 6550 E CONDENSER DRYER ELECTRONIC SENSOR TCS 6550E A B C D E F G H AUTOREVERSE 125994460 INSTRUCTION BOOKLET INSTRUCCIONES PARA EL USO INSTRUES DE UTILISAO GB E P Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages After unpacking the machine please check it is not damaged. If in doubt, do not start it but contact your local Service Centre. The symbols you will see on some paragraphs of this booklet have the following meaning: The warning triangle emphasize information that is particularly important for your safety or correct functioning of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. [. . . ] If the door is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. This button must also be pressed after a power cut and after having re-inserted the water reservoir if it has been emptied in the middle of a programme. In both cases light or (depending on the phase in progress) flashes to remind you that the start button needs to be pressed again. 3 Mains-ON light Comes on when the appliance is switched on (ON/OFF button pressed down) and goes out when this button is released. 4 Low temperature button Pressing this button allows drying to be performed at a lower temperature, for delicate items. Corresponding pilot light 5 comes on and an acoustic sound rings. This option can also be used for time controlled drying. The dryer heats at 1400 W instead of 2400 W. If the button is not pressed, drying is performed at full power (2400 W). 9 Programme phase indicator lights These lights indicate the various phases of the programme as they are being performed. "Drying" light This light indicates that the appliance is in the drying phase. "Cooling" light 5 Low temperature light Comes on when the low temperature drying button is pressed. This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry. If light or is flashing, this means that the Start button needs to be pressed again for the programme to resume. 6 Buzzer OFF button A buzzer sounds when buttons 4-6 and 8 are pressed and during the anti-creasing phase. Press this button when selecting the programme if you wish to switch the buzzer off. 8 "End of programme" light This light flashes at the end of the cooling phase and during the anti-creasing phase. Water full indicator light This light flashes when the water reservoir is full. 10 Operating sequence Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes. There may be dust inside a brand new tumble dryer. After each use Turn the programme selector dial to "0". Switch the appliance off by releasing the ON/OFF button . Clean the filter and empty the water reservoir (see page 13). If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance. Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to "0". Select the new programme and press the Start button . Drying 1. Open the door by pressing the relevant button. Load the items one at a time, shaking them out loosely. Please check the laundry does not get caught between the door and filter. [. . . ] The filter collects all the fluff which forms during drying and it is therefore essential to remove and clean this filter after each drying programme using a damp cloth. Pull the filter upwards in order to remove it. Emptying the water reservoir Water extracted from the laundry condenses inside the machine and is collected in a reservoir. The reservoir must be emptied after each drying cycle to ensure efficient operation when the machine is next used. If this is not done a safety device trips: pilot light on the control panel comes on and the programme stops, leaving the laundry damp. [. . . ]