User manual ZANUSSI TD301

[. . . ] Tips and information about economical and ecological use of the machine are marked with this symbol. Our contribution to the protection of the environment: we use environmentally friendly paper. 2 Contents Warnings Disposal 4-5 5 International wash code symbols Operating sequence Washing only Drying only Automatic washing and drying Washing programmes Drying programmes 14 15-17 15-16 17 17 18-19 20 Tips for environmental protection 5 Technical specifications Installation Unpacking Positioning Water inlet Water drainage Electrical connection 6 7 7 7 7 8 8 Maintenance Bodywork Detergent dispenser drawer Drain filter Water inlet filter Emergency emptying out Frost precautions 21 21 21 21 21 22 22 Description of the appliance Detergent dispenser drawer 9 9 Something not working? 23-24 Use Control panel Controls Washing hints Sorting the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives Drying hints Load Garments not suitable for drying Drying symbols on garment labels Duration of the drying cycle Fibre residue Additional drying 10 10 10 11 11 11 11 11 11 11 12 13 13 13 13 13 13 13 3 Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation · All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book. [. . . ] Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. residual marks with bleach. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load, ­ the laundry is lightly soiled, ­ large amounts of foam form during washing. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Select the temperature Turn the dial to the required setting. 90 P0004 M0045S 2. Measure out the detergent Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out the prewash, pour detergent into the appropriate compartment marked . 6. Select the required programme Turn the programme selector dial clockwise to the desired position. B 3. Measure out the additive If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark. M0046 C0064 C0065 15 7. Start the machine Depress the ON/OFF button: the mains-on light will illuminate and the machine starts operating. ON/OFF 8. At the end of the programme The machine stops automatically. If you have selected a programme which ends with the water of the last rinse in the tub, drain the water before opening the door by selecting programme P (drain) or J (drain and short spin). The door is controlled by a safety device which releases 2 minutes after the end of the programme. [. . . ] · Too much detergent or unsuitable detergent (creates too much foam) has been used. · Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. · Too little detergent or unsuitable detergent has been used. [. . . ]