User manual ZANUSSI TD4110

[. . . ] If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely. This tumble dryer is designed to be vented through to the open air. It should have its own ventilation system which should not be joined with any other ventilation system connected to any other appliance. General safety It is dangerous to alter the specifications or attempt to modify this product in any way. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Remove the laundry when the dryer has finished drying. If individual items are still damp after drying, set a brief post-drying time, but at least 20 minutes. This will be necessary particularly for multilayered items (e. g. Clean the filter regularly to avoid excessive drying times and high electricity consumption. The room temperature should not exceed +35C during drying. To utilize the maximum load, laundry which is to be dried ready to put away (store dry) can be dried together with items to be ironed. To do this, select the programme for iron-dry, remove the iron-dry items at the end of the programme and then finishdry the rest of the load. Never tumble dry the following: Particularly delicate items such as net curtains, woollen, silk, fabrics with metal trim, nylon tights, bulky materials such as anoraks, blankets, eiderdowns, sleeping bags, feather quilts and any items containing rubber foam or materials similar to rubber foam. Always follow the instructions on garment labels: may be tumble dried normal drying (high temperature) delicate drying (low temperature) do not tumble dry Close pillowcases and covers with fasteners to prevent small laundry items getting tangled inside them. Close press studs, zips and hooks and tie belts and apron strings. 5 ENGLISH 125993430. qxd 9/4/02 8:38 AM Pagina 6 Installation Positioning It is recommended that, for your convenience, the machine is positioned close to your washing machine. Whilst drying, the tumble dryer will expel a certain amount of warm, very moist air, and this should be removed from the room as quickly as possible to prevent condensation. In an extremely well ventilated room or close to an open window, this may occur naturally. However, in general, it is better to carry the dryer's exhaust outside via the 100 mm diameter flexible hose supplied with the appliance; ending either temporarily at an open window, or permanently at a fixed ventilation grille, fitted to an exterior wall or window. The tumble dryer must be installed in a clean place, where dirt does not build up. Make sure there are no obstructing items or material near the air-intake louvres provided at the back (e. g. To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is. Fitting the vent hose To simplify the installation, there is a choice of vent outlets: one at the back, the others in the left and right-hand side. Connect the hose to whichever is the more convenient by pulling the ring nut (A) from the vent outlet at the back, screwing it on to the hose and pushing it firmly back into place. The unused vents should now be sealed with the special snap covers provided. A P1028 A P1027 Advice: If the hose is long and the room temperature low, the moisture might condense to water inside the hose. This is an unavoidable natural phenomenon. To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (dia. 3 mm) in the lowest point of the hose and to place a small container below it. (See picture, point B). P0046 The feet must never be removed. [. . . ] The selector dial is not set correctly. The dryer does not dry properly: The filter is clogged. The selected cycle is not suitable for the laundry. The laundry has not been spun properly. The dryer is not correctly installed. If, after the above checks, there is still a fault, call your local Zanussi Service Centre. [. . . ]