User manual ZANUSSI TD50

[. . . ] - - - - - - - - - - - - - - - - - - - - - 25 Technical data- - - - - - - - - - - - - - - - - - - - - 29 Consumption values - - - - - - - - - - - - - - - - 30 Installation instruction - - - - - - - - - - - - - - - 31 Fitting under a counter- - - - - - - - - - - - - - - 34 Environmental concerns - - - - - - - - - - - - - 35 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] · press button 8 again to start the programme. · If the programme has already started, the 17 selected delay can be modified only after you have turned the programme selector dial to the «O» position and after you have selected the programme again. · The door will be locked throughout the delay time. If you need to open the door, you must first set the washer dryer to PAUSE by pressing button 8 . After you have closed the door, press the same button again. The Delay Start cannot be selected with «Drain» programme. Select an additional rinse This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse) Press simultaneously buttons 4 and 6 for a few seconds until the pilot light 9 will light up. To remove this function press the same buttons again until the pilot light 9 goes off. Start the programme by pressing button 8 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The appliance starts operating and the door is locked. select the Drain»or «Spin» programme 3. reduce the spin speed, if needed, by pressing button 3 4. at the end of the programme, the display shows the display shows «0. 00», it will be possible to open the door. Turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Drying only The max load to dry in your washer -dryer is 3. 5 kg for cotton and 2 kg for synthetics. The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. Turn the selector dial to «Cottons» or «Synthetics» programme in the «Drying» sector. If you wish to select the automatic drying (Exta dry, Store dry or Iron dry), press button 4 until the light corresponding to the desired dryness degree for synthetics or cotton illuminates. If you wish to select a timed drying, press button 5 until the time you want appears on the display (see the drying programmes). [. . . ] Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door and in the chapter «Technical Data». Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution. [. . . ]