User manual ZANUSSI TH450W

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 2 IMPOR TANT S AFET Y INS TR UCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. [. . . ] Remaining small ice and frost stains on back plate of the refrigerator after defrosting period is not abnormal. The freezer can not be equipped with automatic defrosting set since the deep-frozen and frozen foods do not endure melting temperature. When small frost and ice occurs scrape off and remove frost and ice coating with the supplied plastic scraper. When ice coating is so thick that it cannot be removed with the plastic scraper, the cooling gill have to be defrosted. Frequency of defrosting depends on usage (generally 2-3 times a year). Take the frozen foods out of the appliance, and put them into a basket lined with paper or cloth. Store them in a possibly cool place or replace them into another refrigerator. Pull out the mains plug from the mains socket, so both parts of the appliance are out of operation. Open the doors of both parts of the appliance and clean the refrigerator according to 'Regular cleaning'. Maintain and clean the freezer as following: Sweep off the melting water with a cloth or sponge in direction of sides of the cooling plates. The melting water swept down gathers in the outlet channel practically formed in the bottom of the appliance and can be removed according to figure. Products in big quantity to be frozen were put in. Products to be frozen are placed too closely to each other. During automatic defrosting plate of the refrigerator. Water flows into the The outlet of the chamber can be chamber. Products placed in can prevent water from flowing into the collector. Water flows onto the The melting water outlet flows not into floor. the evaporative tray above the compressor. There are too much frost Products are not wrapped properly. Doors are not shut properly or do not close tightly. The thermostatic control can be set wrongly. The compressor The thermostatic control is set wrongly. [. . . ] (fig. 2) Fit the pin of the double door hinge (m) into the left drill of the freezer door. (fig. 2) Fit the freezer door to the lower door hinge pin (f). (fig. 3) Fit the refrigerator door to the upper door hinge pin (d) then slightly tilting both doors fit the pin of the double door hinge (m) into the left drill of the refrigerator door. Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). [. . . ]