User manual ZANUSSI TL552C

[. . . ] Be careful : The lid can only be opened 1 to 2 minutes after the machine has stopped. After each wash : · press out the on/off pushbutton ; the control lamp lights off. · press out the pushbuttons if necessary. [. . . ] 1 - Dismantling Turn the two screws round a quarter with a screwdriver or a coin in order to take away the detergent dispenser. The detergent dispenser is very easy to remove, you just have to slide it towards the top. Clean the detergent dispenser under running water with a brush or a twisted rag. 2 - Reassembly Reposition the detergent dispenser at its place proceeding the opposite way. This appliance complies with the following EC Directives : - 72/23/EEC of 19. 02. 1973 - Low-Voltage Directive - 89/336/EEC of 03. 05. 1989 (including Amentment Directive 92/31/EEC) EMV Directive. Removal of the internal packing Fig 1 Electrical connection Before you plug the appliance into the wall socket, make sure that : · The supply voltage of the domestic wiring system does not fluctuate by more than 10% plus or minus from the value shown on the rating plate. · The meter, the fuses, the supply line and the wall socket are all suitable to carry the maximum load required by the washing machine (2, 3 kW). The existing safety rules call for the appliance to be connected to an efficient ground wire. The manufacturer disclaims any liability whatsoever if this accident prevention rule is not complied with. The replacing of the power cord must This appliance complies with E. E. C. directive n° 87-308 only be realized by the After Sales of 06. 1987 relative to radio interference suppression Service. directive n° 73-23 relative to electrical safety. The parts protecting the inner components of the machine during transit are red. They must all be removed before using your machine for the first time. These parts and their securing means should be kept in case the machine has to be transported again. Give to one of the back corners a quarter turn. The appliance comes free naturally out the polystyrene basis. Open the lid of the appliance and remove the polystyrene wedge which blocks the drum. [. . . ] 3 Fig 6 If you want to keep the alignment of your appliance with the adjacent cupboards, you have the possibility to cut the crossbar holding the hoses located in the back of your washing machine (fig. 6). - open the flapdoor covering the filter by pressing the left hand side of the filter door (fig. [. . . ]