User manual ZANUSSI VF45

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. [. . . ] ­ Dishes and items of cutlery must not lie inside one another, or cover each other. ­ To avoid damage to glasses, they must not touch. ­ Lay small objects in the cutlery basket. · Plastic items and pans with non stick coatings have a tendency to retain water drops; these items will not dry as well as porcelain and steel items. · Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: · Cutlery with wooden, horn, china or mother-of· Only wash stoneware in the dishwasher if it is pearls handles. specially marked as being dishwasher-safe by the manufacturer. · Plastic items that are not heat resistant. · Older cutlery with glued parts that are not tempera- · Glazed patterns may fade if machine washed frequently. · Silver and aluminium parts have a tendency to dis· Bonded cutlery items or dishes. egg white, · Pewter or copper items. egg yolk and mustard often cause discolouring and · Lead crystal glass. Therefore always clean left-overs · Steel items prone to rusting. If you want to exclude the "Multi-Tab function" you have to cancel the programme setting and then deactivate the "Multi-Tab function". In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multi-Tab function Press simultaneously the two buttons positioned over the Multi-Tab symbol, until the "Multi-Tab function "indicator light illuminates. To deactivate the function press the same buttons again until the indicator light corresponding to the "Multi-Tab function" symbol turns off. IMPORTANT!If the drying results are not satisfactory we suggest that you: 1. · Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid dispenser can only be possible with the "Multi-Tab function" active. Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons B and C, until the indicator lights of buttons A, B, and C start flashing. Press button B, the indicator lights of buttons A and C turn off while the indicator light of button B goes on flashing. To activate the rinse aid dispenser, press button B again, the end of programme indicator light illuminates, indicating that the rinse aid dispenser has been activated. To memorise the operation, switch off the dishwasher by pressing the On/Off button. [. . . ] Take care when installing the water inlet hose . Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve. If the water inlet hose or the safety valve is damaged, remove the mains plug immediately. A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre. 26 Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. [. . . ]