User manual ZANUSSI WDT1055W

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. [. . . ] After a few seconds: ­ programme light B turns off ­ programme light A goes on flashing ­ End of programme light starts flashing: the number of flashes corresponds to current level set. The flashing is repeated with a pause of a few seconds. Examples: 5 flashes, pause, 5 flashes, pause, etc. . . To change the level, press the Programme selection/Cancel button. Each time the button is pressed the level increases (level 1 follows level 10). The End of programme light indicates the new setting. To memorise the operation, switch off the dishwasher. 11 Filling with dishwasher salt CAUTION!Use only special salt suitable for dishwashers. Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT!Top up the special salt when the light on the control panel illuminates. 12 Filling with rinse aid Open the lid. Fill up with rinse aid. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. 18 Cleaning the spray arms NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. [. . . ] Take care when installing the water inlet hose . Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve. If the water inlet hose or the safety valve is damaged, remove the mains plug immediately. A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre. Water inlet hose with safety valve Connect the inlet hose to a water tap with an external thread of 3/4". 24 Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. [. . . ]