User manual ZANUSSI WS1094H

[. . . ] After this symbol you will find supplementary information on operating and practical use of the appliance. Tips and instructions for the economical and environmentally sound use of the appliance are marked with this symbol. These instructions contain informations on how to rectify faults yourself. " Should you require further assistance, please contact your local Service Force Centre. 2 Content For the user Dear Customer ! [. . . ] All cooking zones and settings can be used as normal. D Deacitivating the child-safety device The child--safety device can only be deactivated when the hob is switched off. is indicated in the 2 2 1 D 2. Touch and controls at the same time for about 2 seconds and the release. Symbol will go out in the digital displays and will be indicated. The child--safety device is now deactivated. 10 3 D Safety cut off after a time If a cooking zone is not switched off or if a setting is not varied after a defined time, the corresponding cooking zone will switch off automatically. appears in the cooking zone display and cooling down. D The cooking zones switch off as follows: S setting 1 ­ 2 after 6 hours S setting 3 ­ 4 after 5 hours S setting 5 after 4 hours S setting 6 ­ 9 after 1. 5 hours after To re--set the cooking zones, if required, the appliance must be switched back on using the main switch ON/OFF. Safety cut off due to a spillage Liquids that boil over and spill onto the surface will cause the cooking zones to switch off. The hob will also switch itself off if a wet cloth is placed on the control panel. In either case the appliance must be switched back on, once the liquid or cloth has been removed, with the main switch ON/OFF for further use. 11 Application, Charts, Tips Cooking and frying utensils The better the pot or the pan, the better the boiling or frying result. D You can recognise good quality pans by their base. Once the cooking zone has cooled down it can be operated again. if the cooking zones will not function? Check, whether D D D D D D the main fuse has failed. the control lamps of the control panel are lighting. the corresponding cooking zone is switched on. the cooking zones are set for cooking as desired. . . . if cooking zones cannot be switched on/off? Check, whether D D the control panel is locked. a period of more than 10 seconds has elapsed between pressing the on/off switch and selecting a cooking zone. the touch controls are entirely or partly covered by liquid or by a wet cloth. If the hob has been used at a high setting for a long period of time, the overheating protection of the electronic control will become active and the front left cooking zone will become inoperable. This occurs to prevent damage to the electronic controls. The front left cooking zone will operate again once the appliance has cooled down and is no longer in the display. The front right and rear cooking zones can still be operated during this time. . . . [. . . ] The heating element voltage amounts to 230 V ~. The appliance will also perfectly perform with the former mains voltage of 220 V ~. The mains connection must be carried out in a way that an all--pole insulating device is existing with a contact opening of at least 3 mm, e. g. LS-automatism, earth--leakage circuit--breaker or fuse. [. . . ]