User manual ZANUSSI Z 8050 WOS

[. . . ] 85 COOKER Z 8050 WOS Instruction for the use - Installation advice Dear Customer, We thank you very much for choosing our products. The instructions and advice included in this booklet are given to safeguard your safety and to use this appliance correctly. It will be useful to clear any doubt concerning its operation. This appliance must be only assigned to the use for which it has been realized, that is for cooking food. [. . . ] They will remain always perfect if cleaned with products used for silverware. After cleaning or wash, check that burnercaps and burner-heads are dry before placing them in the respective housings. Special attention has to be paid in order not to exchange the housing of the two small burners shown in fig. It is absolutely necessary to check the perfect housing of the burner-ring as an incorrect housing may cause serious inconvenience. Check also that the electrodes for ignition be always clean in order to ensure a regular spark shooting. CLEANING All the enamelled parts must be cleaned with a sponge and soapy water or other non-abrasive products. Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage the enamel if left too long. STAINLESS STEEL, ALUMINIUM PARTS AND SILK-SCREEN PRINTED SURFACES Clean using an appropriate product. IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abrasion. You are advised to use a soft cloth and neutral soap. CAUTION: Do not use abrasive substances or non-neutral detergents as these will irreparably damage the protective surface. REPLACING THE OVEN LIGHT BULB Switch the cooker off at the mains. Unscrew and replace the bulb with another one resistant to high temperatures (300°C), voltage 230 V (50 Hz), 15 W, E14. INSIDE OF OVEN Fig. 6. 2 This must be cleaned every time it is used. Remove and refit the side runner frames as described on the next chapter. With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy water or another suitable product. The bottom of the oven, side runner frames, tray and rack can be removed and washed in the sink. 16 Burner-cap ring fully drilled Burner-cap ring partially drilled Fig. 6. 4 OVEN DOOR The internal glass panel can be easily removed for cleaning by unscrewing the 4 retaining screws (Fig. 6. 3) STORAGE COMPARTMENT The storage compartment is accessible through the pivoting panel (fig. 6. 4). Do not store flammable material in the oven or in the storage compartment. 17 REMOVING THE OVEN DOOR The oven door can easily be removed as follows: Fig. 6. 5A ­ Open the door to the full extent (fig. 6. 5A). ­ Attach the retaining rings to the hooks on the left and right hinges (fig. 6. 5B). ­ Hold the door as shown in fig. ­ Gently close the door and withdraw the lower hinge pins from their location (fig. [. . . ] 8. 13) about three times by a flat screwdriver ­ let the oven heat up for about 10 minutes, then bring the thermostat to position 1 (minimum) to operate the thermostat by-pass ­ slowly screw the by-pass screws "G" (fig. 8. 13) until you obtain a flame of 34 mm in height. For G30/G31 the by-pass screw must be fixed thoroughly. Flame correct Flame faulty in primary air Flame with excess primary air G Fig. 8. 13 IMPORTANT All interventioni regarding installation maintenance and conversion of the appliance must be fulfilled with original factory parts. [. . . ]