User manual ZANUSSI Z100-DW-

[. . . ] 7 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-9 Hose Blockage . . . . . . . . . . . . . . . . . . . . . . . . 10-11 Brush Roll . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Brush Roll Belt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14-15 Dirt Alert Feature . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Problem Solving . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Pull handle back to a comfortable position. Store or Use Attachments 1 4 ON/OFF Handle Release 3 2 2 4 ON/OFF Use 3 Handle Release Clean Under 3 Handle Release LO W 1 HI GH Cleaner Height Setting WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting. The front of the cleaner has an adjustment that raises or lowers the cleaner base to match the type of carpet. With the cleaner cord unplugged, set the adjustment to lowest setting for maximum cleaning. If the cleaner is difficult to push, move adjustment to next highest setting until cleaner is comfortable to push. The brush roll must reach the carpet for effective cleaning. NOTE: For ease in moving the adjustment knob, place handle in operating position and tilt cleaner back to remove weight from front wheels. NOTE: When handle is in upright position, brush roll is lifted off carpet. Height adjustment will not change brush roll level until the cleaner's handle is moved into the operating position. Thermal Cut Off This cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure: 1. Remove the handle from the vacuum cleaner by removing the two screws and sliding the handle towards the rear. Once the handle is removed, disconnect the attachment hose from the unit by lifting straight up on the hose adapter. Check for any obstructions that may be in the hose. Any obstructions can be removed by using a blunt instrument to clear the hose. Flexing the hose may help loosen the clog. Reinstall the hose after clearing the clog. Make sure the hose is inserted into the top of the vacuum cleaner before reattaching the handle. NOTE: If no improvement in performance on carpet, proceed to following page. Remove hose and check suction at end of hose. 2 4 3 # 2. Reinstall the hose and handle. How to Check and Clear Blockages in Base 1. Remove the attachment hose from the lower hose retainer and look into the hose retainer for any obstructions. [. . . ] The chamber with the screen will fill much faster than the chamber with the cone. When the chamber with the screen is full, empty cyclonic cassette, do not wait till the chamber with the cone is full. Replace a cut, loose or out of shape belt. Clean hair and thread from bristles and end cap area. [. . . ]