User manual ZANUSSI Z1373

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions under Door reversal. Positioning This appliance is designed to operate in ambient temperatures between 10C (50F) and 32C (90F). It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e. g. not next to a boiler or radiator, or in a very cold room e. g. an outhouse, where the temperatures may fall below 10C (50F). colder or warmer, then the appliance may not operate correctly. You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B). There should also be a gap of 25 mm either side of the appliance. The back of the cabinet may be placed close to the wall but must not touch it. Remove suspect food from your refrigerator and clean (refer to Maintenance and Cleaning). Never allow spillages to dry and harden. Ensure that food placed in the freezer is dated and labelled and used in date order to ensure that food is consumed at its best. It is important that food is used before its best before date. Store eggs in the egg rack provided in the refrigerator door. Regularly check the refrigerator door seal to ensure that it is clean and free from debris. Always wash your hands with soapy water and dry them with a clean towel before handling food. Keep work surfaces clean and avoid cross contamination by not using the same work surface or knife, without washing them thoroughly in between. The fresh foods to be frozen must be fresh and of the best quality. The size of each pack should be small enough to ensure that it is used in one go . Small packs freeze more quickly and uniformly and give better results. [. . . ] Replace the scraper in one of the drawers . Reconnect the appliance to the mains or reset the thermostat control knob to a functioning position. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. D068/2 SOMETHING NOT WORKING Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: Symptom No power to the appliance Solution Check there is power at the socket. [. . . ]