User manual ZANUSSI Z468TX

[. . . ] - - - - - - - - - - - - - - - - - - - - 22 Technical data- - - - - - - - - - - - - - - - - - - - - 25 Consumption values - - - - - - - - - - - - - - - - 26 Installation instruction - - - - - - - - - - - - - - - 27 Environmental concerns - - - - - - - - - - - - - 30 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out a programme with the prewash phase, pour it into the compartment marked . If required, pour fabric softener into the compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Select the required programme by means of the programme selector dial (1) Turn the programme selector dial to the required programme. The green light of button 8 starts to flash. It can be turned either clockwise or anticlockwise. On position «O» the programme is reset and the machine is switched OFF. IMPORTANT!If an option which is not compatible with the set wash programme is selected, the message Err is displayed for a few seconds and the red light of this button flashes for 3 times. Select the delayed start by pressing the button 10 Depress this button to select the required delay. The selected delay time value will appear on the display for a few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O». After a few minutes the door can be opened (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then to depress button 8. At the end of the programme The machine stops automatically. Some acustic signals sound and on the display will appear a flashing «0 ». The light of button 8 and the light 9 go off. If at the end of a programme there is water in the tub, the light 9 remains on and the door is locked to indicate taht the door must be empty out. To empty out the water follow the following instructions: 1. turn the programme selector dial to «O» 2. reduce the spin speed, if needed, by pressing the button 2 4. at the end of programme, the display shows a flashing zero «0», the light 9 goes off and it will be possible to open the door. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. [. . . ] Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. Attenzione!Angle the hose to the left or right depending on the position of your water tap. [. . . ]