User manual ZANUSSI Z713VSP

[. . . ] Ensure that the appliance does not stand on the electrical supply cable. If the supply cable is damaged, it must be replaced by a cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Parts which heat up should not be exposed. [. . . ] The inner temperature is normally uniform and is kept cool by cold circulating air. Try to avoid putting food products flush against the air vents at the back of the fridge as this could cause the foods to freeze. Chill Compartment Freezer Compartment The freezer will store frozen food at -18°C or colder allowing for long-term frozen food storage and freezing of fresh food. The temperature is kept typically at 1-2 degrees lower than the average temperature in the fridge. Use the compartment for foods that are marked typically for storage at 0-5°C for longer preservation. Adjusting the fridge temperature to cooler or warmer affects the chiller temperature in the same way. Avoid stacking large amounts of warm food on top of already cold food, as this will raise the temperature of the food previously stored in the chiller. Do not use the chiller, as a zone for rapid cooling at it is not designed for this. 5 Maintenance and Cleaning Before any maintenance or cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY supply. Your appliance is frost free, which means there is no need to manually defrost your appliance, as this will be carried out automatically. Defrosting Changing the light bulb External Cleaning Wash the outer cabinet with warm soapy water. Do not use abrasive products. There may be sharp edges on the underside of the product so care should be taken when cleaning. Ensure the vents at the back of the appliance are clear of dust and debris etc. 1. Switch off the appliance by pressing the ON/OFF button, and then unplug the appliance. Open the plastic light cover, by pushing upwards on the centre clip. Unscrew the light bulb and replace with a bulb with the following specifications: Clear Halogen E14 screw thread 220-240 Volts 25 watts (max) Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). Rinse and dry thoroughly. Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. 1 halogen bulb 25W When the appliance is not in use for long periods, disconnect from the electricity supply, empty all of the food and clean the inside of the appliance. Increase the room ventilation. The appliance does not cool down sufficiently The doors have not been closed properly A door has been opened frequently The temperature control knob is not set correctly Food has been introduced into the appliance Food is freezing in the fridge The temperature control knob is incorrectly set Food is too close to ventilation holes at the back The motor works continuously. Temperature control knob is incorrectly set The doors are not properly closed Doors have been opened frequently Food has recently been introduced into the appliance The condenser is dirty Water/condensation in the vegetable drawer Condensation on the outside of the cabinet Doors do not close Wet vegetables have been put into the box High humidity level in the room. The appliance is not level The doors are incorrectly aligned Food is preventing the doors shutting Level the appliance correctly Re-align the doors Re-position food Level the appliance Check the contents and shelves are properly positioned. Contact your local Service Force Centre Noises The appliance may not be level Something may be vibrating inside All product lights start flashing and the alarm sounds 8 Your product has a major fault Normal Operating Sounds 1. Temperature control Cooling system Motor Fans May cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. May cause a humming noise and or slight knocking sound. You may occasionally hear the fans working. This is normal; the fans help to ensure the air circulates more effectively. Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. The addresses are listed on the following pages. Before calling out an engineer, please ensure you have read the details under the heading «Something Not Working». When you contact the Service Centre you will need to give the following details. Your name, address and postcode Your telephone number Clear and concise details of the fault The model and serial number of the appliance (found on the rating plate) The purchase date Customer Care Department Customer Care Department Zanussi 55-77 High Street Slough Berkshire SL1 1DZ 08705 727727 * For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www. zanussi. co. uk * Calls to this number may be recorded for training purposes. 9 GUARANTEE CONDITIONS Standard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained repaired, taken apart or tampered with by any person not authorized by us. All service work under this guarantee must be undertaken by a Zanussi Service Force Centre. [. . . ] (Fig 3) Climate Classification SN N ST T Ambient Operating Temp. +10 to +32°C +16 to +32°C +18 to +38°C +18 to +43°C rating plate Fig. 3 If the temperature rises above or falls below the stated ambient temperature for the climate class, the operation of the appliance may be affected. Ventilation You should also ensure that air can circulate freely around the back and the top of the cabinet. Never put something on the ventilator grill of the appliance (see fig. [. . . ]