User manual ZANUSSI Z9050G

[. . . ] Any other use has to be considered incorrect and therefore dangerous. Themanufacturer declines any liability for damages caused by wrong, incorrect or irrational use of the appliance. IMPORTANT INSTRUCTION AND ADVICE FOR THE USE OF ELECTRICAL APPLIANCES The use of any appliance requires the compliance with some basic rules, namely: ­ do not touch the appliance with wet or damp hands (or feet); ­ do not use the appliance bare feet; ­ do not allow the appliance to be operated by children or disabled without overseeing. The manufacturer cannot be deemed responsible for damages caused by wrong or incorrect use. USEFUL HINTS After removing the appliance from its packing, make sure of its integrity. [. . . ] 3. 9 9 4 - GENERAL ADVICE * When the appliance is not being used, it is advisable to keep the gas tap closed. From time to check to make sure that the flexible tube that connects the gas line or the gas cylinder to the appliance is in perfect condition and substitute it at printed due date, or if it shows signs of wearing or damage. * In case of difficulty in the gas taps operation, call Service. Do not close the cooker lid when the burners or grill are still hot and when the oven is on or still hot. Do not rest hot pans or heavy objects on the cooker lid. Remove any spillages from the surface of the cooker lid before opening. GLASS LID For cleaning purposes, the lid can be easily removed upwards once taken to the upright position. Should the hinges slip off, replace them in their housing being careful that: ­ The right housing must receive the hinge marked "D" while the left housing must receive the hinge marked "S" (fig. REGULATING OF THE BALANCE Lower the lid and check the correct balance. While opened at 45° it should hang up. If necessary, register the calibration of the hinge springs using the screws "R". Attention: The cooktop becomes very hot while operation. Failure to observe this rule will invalidate the warranty. instructions suppliedby the manufacturer. ­ The appliance must be installed in compliance with the laws in force in your country and in observation of the ­ The electrical mains outlet, if located behind the cooker, must not be higher than 18 cmabove the floor level. ­ The surfaces of adjacent furniture and walls must b e capable of withstanding temperatures in excess of 75° C. ­ Some appliances are supplied with a protective film on steel and aluminium parts. This filmmust be removed beforeusing the cooker. 13 INSTALLATION The cooker afford class "1" protection against overheating of surrounding surfaces. A space of at least 2 cm must be left between the cooker and any adjacent furniture, which must not exceed the height of the cooktop (fig. 5. 3). The walls of the units must not be higher than work top and must be capable of resisting temperatures of 75°C above room temperature. Do not install the appliance near inflammable materials (eg. 5. 3 14 CHOOSING SUITABLE SURROUNDINGS In the room chosen to accommodate the gas appliance, there must be an adequate natural draft to allow combustion of the gas. 6. 1 16 1 -GAS CONNECTION The connection must be executed by specialized fitter according to the relevant standard. 6. 2) ismadeupof: - 1 elbow fitting "A" - 1 adapter "C" for natural gas - 1 adapter "B" for L. P. G. - gasket "D" ­ Fit up the holder "C" to the elbow "A" interposing The rubber tube: ­ must be as short as possible, without contractions or kinks; ­ must be easy to inspect along its entire length to check its wear; ­ must never be at any point in its length in contactwith the "hot" parts of the cooker. [. . . ] ­ fit the knob and let the oven heat for 10 minutes, then take the knob to position 1 allowing the thermostat to work under by-pass. ­ after further removal of the knob, stop slowly the screw by-pass (being careful not to turn the knob) until the flame reaches 3-4 mmhigh. For G30/G31 the by-pass screw must be fixed thoroughly. The grill burner has an only fixed input. IMPORTANT All intervention regarding installation maintenance and conversion of the appliance must be fulfilled with original factory parts. [. . . ]