User manual ZANUSSI ZAN1665

[. . . ] Always insist on genuine Zanussi spare parts. Ensure that all control knobs are in the OFF position when not in use. Should you connect any electrical tool to a plug near this cooking appliance, ensure that electric cables are not in contact with it and keep them far enough from the heated parts of this appliance. If the appliance is out of order, disconnect it from the electric supply. About Installation, Cleaning and Manteinance · It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. [. . . ] Check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" (Fig. To put the flame out, turn the knob to the symbol q. · Always turn the flame down or put it out before taking the pans off the burner. 1 FO 0204 USING THE HOB CORRECTLY To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (see the table beside). It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering. · Use only pans or pots with flat bottom. Table of minimum and maximum diameters of pots which can be placed on the burners Burner minimum diameter 160 mm. 160 mm. Big (rapid) Small (Auxiliary) 31 2. Cleaning and Maintenance · Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Carefully wash the stainless steel components with water, then wipe them dry with a soft cloth. Interpose the sealing between the components as shown in fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. The adjustable connection allows the feeding pipe to be situated in the site purposefully allocated on the side of the protection box of the hob itself (Fig. This connection allows the overall dimensions of the hob plus the fedding pipe to be contained into a depth of 30 mm. IMPORTANT - When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Use some soapy water, never a flame. FO 0264 Fig. 3 FO 0265 A) Ramp ending with nut B) Adjustable connection C) Rigid or flexible metallic gas pipe Fig. Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. The appliance is supplied with a connection cable. [. . . ] · Turn the knob on the minimum position. · With a thin screwdriver, adjust the by-pass screw (see Fig. If changing from natural gas to LPG, completely tighten clockwise the screw, until a small regular flame is obtained. Finally check the flame does not go out when quickly turning the knob from the maximum position to the minimum position. [. . . ]