User manual ZANUSSI ZBA3224A

[. . . ] Otherwise, contact your dealer before proceeding with the installation. · This appliance is meant to operate with a single-phase or a three-phase connection to 230V electrical supply, or to a double-phase with neutral wire or three phase with neutral wire 400V electrical supply. A polyphasic 400V connection without neutral wire will cause the destruction of the oven and the combined hob. The manufacturer disclaims any responsability should all the safety measures not be carried out. · · · Child Safety · This appliance has been designed to be operated by adults and children under supervision. [. . . ] Within 5 seconds, press button " " to select the required end of cooking time, which is shown at the right hand of the time display (Fig. 17). After another 5 seconds after you have set the time, the symbol stops flashing, the thermometer symbol comes off, the temperature display shows "30" and the oven switches off. This means that the setting has been stored in the Electronic Control memory and that the countdown started. The oven will switch on and off automatically according to your settings. When cooking is completed, you hear an acoustic alarm while both symbols and flash. The time display shows "0. 00" at the left hand. To switch off the acoustic alarm, press any button. To cancel the programme, simply cancel the Cooking Duration time as described at the end of the previous chapter. Fig. 17 10 Safety and Energy Saving Functions Safety Cut-Off Function The oven will switch off automatically if any change of setting is made, according to the table below (Fig. 18). If temperature setting is: 250°C from 200 up to 245°C from 120 up to 195°C less than 120°C the oven will switch off: after 1 1/2 hours after 5, 5 hours after 8, 5 hours after 12 hours Fig. 18 Child Safety Function To avoid children switching on the oven, it is possible to lock the oven controls. When you press button to switch on the oven, the message "DEMO" appears on the upper section of the display (Fig. 23). You can then select any cooking function, but the oven will not heat up. The thermometer symbol will come on , but it will not flash nor rise. Fig. 22 To disable the demo mode: to switch off the oven, then press button Press button and " " at the same time for approximately 2 seconds. The Electronic Control beeps once and the oven is ready to operate. 23 "Beep" Mode You can choose to make The Electronic Control beep each time that a button is pressed. To enable this function, the oven must be off. and " " at the same time for about 1. The Electronic Control beeps once (Fig. 24). To disable the "Beep" Function: 1. If the oven is on, press button to switch it off. [. . . ] The connection cable has to be placed in order that, in each part, it cannot reach a temperature 50 °C higher than the room temperature. After the connection is carried out, test the heating elements for about 3 minutes. Should the supply cable need to be replaced, use the following cable types only: H07 RN-F; H05 RN-F; H05 RR-F; H05 VV-F; H05 V2V2-F (T90); H05 BB-F. The yellow-green earth wire should be about 2 cm longer than the neutral and phase wires. Electrical connection Before the appliance is connected: 1. [. . . ]