Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ZANUSSI ZBG503A. We hope that this ZANUSSI ZBG503A user guide will be useful to you.
Lastmanuals help download the user guide ZANUSSI ZBG503A.
Detailed instructions for use are in the User's Guide.
[. . . ] You must therefore take great care when using the appliance. Children should be supervised at all times and should not be allowed to touch the hot surface or be in the vicinity when in use or until the appliance has cooled after use. Children also can injure themselves by pulling pans or pots off the hob. The cooking zones heat up quickly when they are turned on. [. . . ] WHEN THE HOB IS FIRST INSTALLED Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory.
ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines to accept any liability should this safety measure not be observed. If the plug fitted to your appliance is not suitable for the socket outlet, it must be cut off and the apprioriate plug must be fitted. The cut off plug should be disposed of to prevent the hazard of electric shocks, should it be plugged into a 13 Amp socket in another part of your home. IMPORTANT The wires in this mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue - Neutral Brown - Live If you fit you own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug. Proceed as follows: connect the green and yellow wire (earth wire) to the terminal in the plug which is marked with the letter 'E' or the earth symbol or coloured green, or green and yellow; connect the blue wire (neutral) to the terminal in the plug which is marked with the letter 'N' or coloured black; connect the brown wire (live) to the terminal in the plug which is marked with the letter 'L' or coloured red.
FO 0390
The plug moulded on to the lead incorporates a fuse. For replacement, use a 3 Amp BS1362 fuse. Only ASTA/BSI approved fuses should be used. The fuse cover/carrier must be replaced in the event of changing a fuse. The plug must not be used if the fuse cover/carrier is lost. A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address and telephone number is listed in the directory toward the back of this instruction book, or you can find your local service centre by looking in your telephone directory under 'Z'.
-
-
5
USE AND CARE
3
1. Hob Top Rapid Burner Semirapid Burner Auxiliary Burner Control Panel Ignition Push-Button Control knob for back left burner Control knob for back right burner Control knob for front right burner Control knob for front left burner Safety cut-off switch Mod. ZBG 503 G ZBG 503 C
2 1 5
6 4 3 2 1 5
10
9
8
7
Mod. ZGA 75 B ZGA 75 W ZBG 503 A
6 4
10
9
8
7
3 2 1 5 11
Mod. ZBG 501 W ZBG 501 B
10 4 6
9
8
7
6
OPERATION
HOB BURNERS To light a burner, turn the relevant knob anticlockwise to maximum position and then depress the ignition pushbutton marked by a small electric spark symbol. To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel. It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering. IMPORTANT Be very careful when frying food in hot oil or fat, as the overheated splashes could easily ignite. IMPORTANT If the control knobs become difficult to turn, please contact your local Zanussi Service Centre. Safety Cut Off The models ZBG 501 B and ZBG 501 W are equipped with a safety cut off device which totally interrupts the gas supply to the hob burners by lowering the hob lid. By lifting up the lid, the gas supply is restored. Light the flame by depressing the ignition push button and remember to turn the gas control knobs to the off position.
FO 0756
MAINTENANCE AND CLEANING
Before any maintenance or cleaning can be carried out, you must DISCONNECT the appliance from the electricity supply. Cleaning your Gas Hob The hob is best cleaned whilst it is still warm, as spillage can be removed more easily if it is left to cool. [. . . ] Visit may be available outside these hours in which case a premium will be charged. Any appliance or defective part replaced shall become our property. * Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic. * Costs incurred for calls to put right machines improperly installed or calls to machines outside the UK and the Republic of Ireland. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANUSSI ZBG503A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANUSSI ZBG503A will begin.