User manual ZANUSSI ZC340R3

[. . . ] For more information, call your · Do not keep carbonised drinks or bottles in the local city office or your dealer. The glass bottles may break. Contents Safety instructions . 13 To start the fridge and set the correct temperature . 13 13 14 14 14 Something Not Working . [. . . ] Cover all foods properly to avoid odours and flavours from tainting other food. Switching off Set the thermostat control to the "0" position. Unplug the power supply plug from the wall socket or, alternatively, remove the fuse. Cabinet interior The shelves and door compartments are removable and can easily be re-arranged. Certain shelves must be lifted up by the rear edge to enable them to be removed. The lower door compartment and the glass shelf above the vegetable drawer must not be moved. They are required for proper air circulation inside the cabinet. Shelves with a raised edge should be placed with the raised edge facing the rear wall of the cabinet, and thus prevent food products from touching the cooling plate. 14 Zanussi 818 14 55-01/8 Hints and Tips Saving energy · Pay careful attention to where the cabinet is placed. See the section "Installation". When installed correctly, the cabinet will consume less energy. Try to avoid keeping the door open for long periods, or opening the door to frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions prevending the door from cloosing properly. This will ensure safer defrosting of foods and reduce the work of the refridgeration unit It is advisable to periodically clean the refrigeration systemat the back of the appliance with a duster or vacuum cleaner. Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear att all times. If bocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. External Cleaning Wash the outer cabinet with warm sopy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Twice a year pull out the cabinet from the wall and vacuum-clean the backside of the cabinet, the refrigerating system and the compressor. When moving the cabinet, lift it by the front edge to avoid scratching the floor. To Change the Light Bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. To replace the lamp in the chiller compartment (only cabinets with two doors), first unscrew the lamp grille with a screwdriver. Use a bulb of the same type, E14 socket, maximum rating of 25 W. When the appliance is not in use Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. 16 Zanussi 818 14 55-01/8 Something Not Working Before contacting your local Service Force Center check the following point: GB Problem It is too warm inside the refrigerator. Possible cause / Remedy Set a lower temperature. Put food products in the right place inside the refrigerator. See the chapter "Temperature inside the refrigerator". [. . . ] Cooling or interior light does not operate. The ventilation space can either be a) directly above the cabinet, or b) behind and above the top cabinet. In this case, the space behind the cabinet must be at least 50 mm deep. If the cabinet is placed in a corner and the side with the hinges faces the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. a) b) 50mm Electrical connection Connect the cabinet to a grounded electrical outlet. [. . . ]