User manual ZANUSSI ZC518-8R

[. . . ] The work of installation must be carried out by The accessories (grid and dripping pan) should be competent and qualified installers according to the washed before using for the first time. Take care when using cleaning products in spray Any modifications to the domestic electrical mains form: never direct the spray onto the resistance or the which may be necessary for the installation of the thermostat bulb. appliance should be carried out only by competent If, when placing food in the oven, or when removing personnel. it, a large quantity of oil, juice, etc. [. . . ] Wait until at least 3/4 of the cooking time has passed before doing this check. As a general rule remember that: a dish which is well-cooked on the outside but not sufficiently cooked inside would have required a lower temperature and longer cooking time. On the contrary, a dry texture would have required a shorter time and higher cooking temperature. For the cooking of meat Meat to be cooked in the oven should weigh at least 1 kilo to avoid its becoming too dry. If you want roasts with a good colour, use very little oil. If the piece is lean, use oil or butter or a little of both. Butter or oil are on the other hand unnecessary if the piece has a strip of fat. If 63 For the cooking of fish: Cook small fish from start to finish at a high temperature. Cook medium-sized fish initially at a high temperature and then gradually lower the temperature. Cook large fish at a moderate temperature from start to finish. Check that baked fish is cooked by gently lifting one side of the gut; the meat must be white and opaque throughout, except in the case of salmon, trout or similar. Moreover, make sure that these are properly re-placed. The burner can be rubbed with steel wool or a slightly abrasive cloth. Clean the oven door and crystal cover, in models equipped with these items, only with warm water, and avoid the use of rough cloths or abrasive substances; in cookers with an automatic ignition the sparkling bulb should be cleaned periodically and accurately to avoid difficulties in lighting; furthermore check that the burner holes are not obstructed. Fig. 9 FO 0424 Cleaning the oven Clean carefully the oven cavity after use when it is still warm. In fact, at this moment it is easy to take off deposits of fat or other substances such as fruit juice, sugar particles or fat. You can use warm detergent water or one of the appropriate spray oven cleaners. Do not direct the spray at the mat steel parts as this could damage them and always follow the manufacturer's instructions. Clean the oven acces-sories (grate, gridplate etc. ) with warm water and detergent. Remove possible incrustations with a slightly abrasive powder. Never line any part of the oven with aluminium foil. It would result in an accumulation of heat which might damage the cooking results and also damage the enamel. Cleaning the oven door For a more complete cleaning of the oven door, it is advisable to disassemble it in the following way (Fig. [. . . ] The brown live wire (originating from the clamp of the cooker junction box) must always be connected to the phase of the mains supply. In any case, the supply cord must be positioned in such a way as it doesn't reach in any point a temperature higher by 50°C than the room temperature. Should the supply cord need to be replaced, use only the following cable types: H05RR-F / H05VV-F / H05V2V2-F (T90). It is necessary that the yellow/green earth wire is about 2cm longer than the live and neutral ones (Fig. [. . . ]