User manual ZANUSSI ZC650

[. . . ] The safety device shouldn't be operated more than 15 sec. When after 15 sec the burner is not ignited, stop pushing of the bottom and wait for at least 1 min before reigning. For manual ignition OVEN 1 2 3 5 GRILL BURNER This burner cannot be adjusted for minimal flow. When using it the oven door has to be half-opened and the protection screen mounted as in the build to avoid overheating of knobs. OVEN or 4 5 6 7 8 Check of ignition Opened for ignition Before the first use of the oven leave it run empty for half an hour on maximum setting. [. . . ] After dipping, rinse and dry them carefully. OVEN Enamelled parts: same cleaning as other enamelled parts. Oven door glass: The inner glass can be removed by unscrewing the two screws. This should be cleaned with a soft cloth soaked in warm detergent water. After cleaning put the glass on place and fix it. Important: The inner glass has to be always in place when using the oven. OVEN DOOR CLEANING For a complete cleaning of the oven door it is advisable to dismantle as follows: -open the door completely -turn the two blocking parts on the hinges arms 60º (the left figure) -close partially the door, to a 30º angle (the right figure) -lift the door and pull it out For assembling proceed conversely. 8 9 CHANGE OF BULB: Stop the power supply. Unscrew the bulb and replace it with one of the same type E14, 220V, 15W, 300ºC. Fix the protector in place. GREASING OF TAPS: It can happen sometimes that a tap turns with difficulty or even block. In such cases the tap interior must be cleaned and greased. Important: This operation must be done only by the maintenance service technician of your distributor. IMPORTANT ! · Any installation work must be undertaken according to the manufacturers instruction and only by an authorised installer. · This appliance has been designed for cooking edible foodstuffs only and must not been used for any other purposes (for instance heating ). · All gas appliances require adequate ventilation. Failure to provide this could result in a lack of oxygen. Prolonged and intensive use of the cooker might request a supplementary aerating e. g. increasing the power of mechanical ventilation, if there is one. · When using the oven or the grill the parts become hot. Children should be supervised at all times and should not be allowed to touch the hot surfaces or be in the vicinity. REPLACEMENT OF THE RUBBER HOSE (if used for connecting) Check the limit date and ask the technician to change it by another one. 10 11 INSTALLATION For the installer and qualified technicians CONNECTION TO THE GAS SUPPLY The gas cooker can be connected to the gas supply on the right side. The gas inlet on the appliance is a 1/2" gas parallel male type. There are 3 possibilities for connecting - rigid pipe with gasket. - rubber hose pipe In case of rubber hose pipe screw on the inlet the hose nipple corresponding to the type of gas supposed to be used interspersing also a gasket. B A C E It is mandatory that all operations required for the installation and maintenance be carried out by a competent gas installer and in accordance with existing rules and regulations. IMPORTANT Before installing check that the technical features on the factory label suit to the gas supplied. This appliance is not connected to a chimney. It must be installed and connected in accordance with the rules and regulation and the relevant codes of practice. Comply with the regulations concerning ventilation. PLACEMENT The gas cooker must be installed in a well-ventilated kitchen, so as to comply with regulation in force. [. . . ] Screw the fixing screw. 14 15 OVEN BURNER - Remove the oven bottom. - Light the burner (knob on position max-flow or 8) and leave the oven door closed for about 10 min. - Turn the knob slowly to position min-flow or 1. - Pull out the knob for adjusting of min-flow - Introduce the screwdriver in the tap's rod at taps without thermostat or near the rod in the left part at taps with thermostat, until to getting a 5mm flame. [. . . ]