User manual ZANUSSI ZCF64

[. . . ] Ensure that the appliance does not stand on the electrical supply cable. If the supply cable is damaged, it must be replaced by a cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Parts which heat up should not be exposed. [. . . ] Do not put any hot food into the fridge or freezer. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. To obtain the best results from your appliance, neither hot foods nor liquids, which may evaporate should be placed in the larder compartment. Avoid buying frozen food if you cannot store it straight away. The use of an insulated container is advisable. When you arrive home place the frozen food in the freezer immediately. Keep the time between buying chilled food and placing it in your fridge as short as possible. Do not push food together too much; try to allow air to circulate around each item. Wrap the food up properly or place it in airtight containers before putting it into the fridge freezer. Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Symptom Interior Light (refrigerator) does not work Cause Appliance is not plugged in The appliance is not switched on There is no power to the appliance The bulb is not fitted correctly or has fused. Solution Plug in the appliance Switch on the appliance Check the main fuse box in the house Refit the bulb or replace with a new bulb Close the doors Avoid frequent opening of the doors Reset as required The appliance will cool down in due course. Reset as required Reposition food, leaving a gap. Change the setting Close the doors Avoid frequent opening of the doors The appliance will cool down in due course. Clean (read the Maintenance & Cleaning section). This may occur from time to time It does not affect the performance of the appliance. Increase the room ventilation. The appliance does not cool down sufficiently The doors have not been closed properly A door has been opened frequently The temperature control knob is not set correctly Food has been introduced into the appliance Food is freezing in the fridge The temperature control knob is incorrectly set Food is too close to ventilation holes at the back The motor works continuously. Temperature control knob is incorrectly set The doors are not properly closed Doors have been opened frequently Food has recently been introduced into the appliance The condenser is dirty Water/condensation in the vegetable drawer Condensation on the outside of the cabinet Doors do not close Wet vegetables have been put into the box High humidity level in the room. The appliance is not level The doors are incorrectly aligned Food is preventing the doors shutting Level the appliance correctly Re-align the doors Re-position food Level the appliance Check the contents and shelves are properly positioned. Contact your local Service Force Centre Noises The appliance may not be level Something may be vibrating inside All product lights start flashing and the alarm sounds 8 Your product has a major fault Normal Operating Sounds 1. Temperature control Cooling system Motor Fans May cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. May cause a humming noise and or slight knocking sound. You may occasionally hear the fans working. All service work under this guarantee must be undertaken by a Zanussi Service Force Centre. Any appliance or defective part replaced shall become the Company's property. This guarantee is in addition to your statutory and other legal rights. Home visits are made between 8. 30am and 5. 30pm Monday to Friday. [. . . ] (Fig 3) Climate Classification SN N ST T Ambient Operating Temp. +10 to +32°C +16 to +32°C +18 to +38°C +18 to +43°C rating plate Fig. 3 If the temperature rises above or falls below the stated ambient temperature for the climate class, the operation of the appliance may be affected. Ventilation You should also ensure that air can circulate freely around the back and the top of the cabinet. Never cover the ventilator grill of the appliance (see fig. [. . . ]