User manual ZANUSSI ZCGHL55WN

[. . . ] ZCGHL55 INSTRUCTION BOOKLET n oit c u d or t nI ZCGHL55 Introduction This gas appliance has been designed and manufactured to all the necessary British Standards. The appliance complies with European Council Directive 90/396/EEC. It is important that you understand how to use and care for the appliance properly before you use it for the first time. We have written this booklet with your safety in mind. [. . . ] If you look after the burner crowns in this way they will stay reasonably clean. However the surface will dull with time. Aluminium based saucepans can leave shiny metal marks on the pan supports. Clean the pan supports regularly to remove the marks using a mild abrasive like 'Cif' with a soft scourer. For more stubborn marks you can use a soap filled pad such as 'Brillo'. After cleaning the appliance parts, dry them thoroughly before you put them back. When replacing hotplate burner parts 1. Crown to body (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the two longer location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side, to side. Cap to crown Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. Check for ignition If a burner will not light then you need to check the crown and cap positions. The grill Do not clean the grill burner itself. The burner is designed to be self cleaning. Cleaning the grill may cause the holes in the burner to become blocked preventing it from operating correctly. Please note that due to the nature of stainless steel the grill burner may tarnish through use over a period of time. This is quite normal and is not a fault on the appliance. Clean the area around the grill frequently using hot soapy water. After use you can soak the pan for a few minutes and then clean it using mild abrasives or a soap filled pad such as 'Brillo'. Mild abrasives can be used if necessary. 28 The top oven Clean the oven and shelf frequently using hot soapy water. [. . . ] There should now be a low gas rate to the burner, which is the F. S. D. valve which allows the main gas supply to the oven burner. After 1 minute check that the flame covers the full width of the burner and is stable. Set the oven control to Mk 2, close the oven door and check that after about 10 minutes the flame size has reduced. [. . . ]