User manual ZANUSSI ZCM1000X

[. . . ] FREE STANDING ELECTRIC COOKER WITH GAS HOB ZCM 1000X INSTRUCTION BOOKLET IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the information in this book contact the Customer Care Department. Telephone 0870 5 727727. INSTALLATION · · · · · · · · · · · · The appliance must be installed according to the instructions supplied. [. . . ] MEAT Beef TEMPERATURES Rare - 60°C Medium - 70°C Well Done - 80°C Well Done - 80°C Medium - 70°C Well Done - 80°C 11. If not eaten straight away after cooking, food should be cooled as quickly as possible (within one hour) and then refrigerated or frozen as required. Do not put hot food into a refrigerator or freezer. In the kitchen keep worktops, chopping boards and utensils clean with hot soapy water between preparation stages. Some of this discolouration may be removed by using proprietary cleaning agents. Remove the burner parts carefully taking care not to damage the spark electrodes. Clean the pan support, burner caps and burner crowns in hot water to which a little washing up liquid has been added. You may use mild abrasives. Do not wash the pan support or burner parts in a dishwasher. Make sure the slots in the crown are not blocked by food or cleaning materials. If you look after the burner crowns in this way they will stay reasonably clean, however, the surface will dull with time. Aluminium pans can leave shiny metal marks on the pan supports. Reduce the marking by regularly cleaning the pan supports and ensuring the bases of new pans are well scrubbed to remove loose deposits. After cleaning the burner parts and pan supports dry them thoroughly before replacing. HINTS AND TIPS · If food spills during cooking move the pan to another burner to finish cooking. Then the soiled parts can be cleaned as soon as they are cool enough and before the spill burns on. Do not leave accidental spillage on the hob or removable parts. The spillage should be wiped up and the parts washed and carefully dried as soon as the hob, pan support and burner parts are cool enough to touch. · Clean the wells of the burner body if spillage has entered when the hob has cooled. 10 REPLACING THE HOB BURNER PARTS 1. Crown to burner body Do not force the crown on to the burner body. Make sure the hole in the crown is over the electrode. Check that the location pegs sit in the slots in the body. Check that the crown can be moved slightly from side to side. Cap to crown Place the burner cap centrally on top of the crown with the enamel side up. Move sideways and front to back to check the cap is properly fitted. Check for ignition If a burner will not light, check the crown and cap positions. REPLACING THE ULTRA RAPID BURNER CAP The Ultra Rapid burner cap is in two parts. Ensure the aluminium part is fitted correctly before placing the enamelled cap in the same orientation on top. [. . . ] 2a 19 INSTALLATION INSTRUCTIONS CONNECTING TO GAS This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be 3 less than R /8. Connection is made to the Rc ½ (½" B>S>P>) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance. NOTE: ONLY LIQUID SEALANTS TO BE USED WHEN INLET GAS PIPE IS FITTED I. E. : DO NOT USE P. T. F. E. [. . . ]