User manual ZANUSSI ZCM5262

[. . . ] INSTRUCTION BOOK ZANUSSI ELECTRIC GAS COOKER Model: ZCM 5262 0 CONTENTS Instructions for the user Technical Features Warnings Description of the appliance Use of the appliance Advice for use Maintenance and clening What to do if the appliance does not work Guarantee conditions 2 3 5 6 12 13 14 15 Instructions for the installer After Sales Service Advice for safety Installation Oven lamp replacement Change of gas 15 16 16 19 20 How to read the instruction book ?The symbols below will guide you when reading the instruction book Safety instructions Description of operations step by step Advice and recommendation Information environment protection 1 TECHNICAL FEATURES Free standing Hob Cover Pan support Front left Back left Back right Front right Oven Over burner power Grill Grill burner power Light in the oven Cleaning Rated voltage Rated frequency Oven grid Dripping pan Protective screen Turn spit Total cooker rating Dimensions Height Breadth Depth 7915 W 875 mm 500 mm 600 mm Enamelled Enamelled Normal electric plate Rapid electric plate Auxiliary Rapid Class 1 1000 W 1500 W 1000 W 2600 W Oven Electric 1700W electric 1800W Lamp 15W type E14 manual 230 /400 V 50 Hz Supply Accessories This appliance complies with the following EEC Directives : 93/68 ; 73/23 (Low Voltage Directive) and subsequent modifications, 89/336, 90/31, 93/68 (Electro- magnetical Compatibility Directive) and subsequent modifications, 90/396 (Gas Appliance Directive) 93/68 (General Directives) and subsequent modifications. 2 WARNINGS It is very important that this instruction book should be kept safety for future consultation. If it should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know the functions of the machine and also be aware of the warnings. This warnings has been given for your and others safety. [. . . ] If for any reason the flame should extinguish turn off the relevant control know, leave for at least one minute and then re-ignite. If after a few attempts the burner does not ignite, check that the burner ring and its cap are correctly positioned (fig. Extinguishing of burners Turn the knob clockwise to mark « device is in place. 11 Burner cap Burner ring Ignition Thermocouple (safety device) fig. 12 Do not put anything on the hob that is liable to melt. Electric Hotplates To switch on a hotplate, turn the relevant control knob to the required heat setting. The control knob is numbered 0 ­ 6 0 ­ OFF 1 ­ Minimum 6 ­ Maximum. The hob has two types of hotplates: Normal Hotplates We recommend the plates are switched to maximum (6) for a short while to boost the plate, and then adjusted to the required setting. Rapid Hotplate (Back left) The rapid hotplates indicated by a red spot, will heat up more quickly than a normal plate. 13 2 0 1 6 5 3 4 To spare the hot plate and for saving power, we advise you: 1. to use flat bottom pots, with the right diameter, never smaller. avoid liquids over flowing when boiling. never leave the plates on without a pot on them or with an empty pot on them. Over a period of time the red spot may disappear, this will not affect the performance of the hotplate. It is important to note that the hotplate may smoke and produce a slightly unpleasant odour when used for the first time. This is quite normal and will disappear after some time. Cooker operation pilot light This light will illuminate when one of the hotplates knobs is turned on and remains lit while the hotplates are in use. Selecting the Correct burner Above every knob there is a symbol for the corresponding burner. For good cooking results, always chose pans, which properly fit to the diameter of the burner used (fig. We recommend the flame is lowered as soon as the liquid starts boiling. For a correct ignition always keep the burner ring and the spark plugs clean. The following diameter pans can be used: Power Diameter (mm) Burner (kW) min. Rapid 2, 60 165 260 Auxiliary 1, 00 120 160 Good use Good use Bad use (Power waste) fig. [. . . ] + neutral 1 2345 N PE L1 L2 L3 N L1 L2 230 V 230 V 20 A 3 x 2, 5 mm² 230 V 230 V 16 A 4 x 1, 5 mm² 230 V / 400 V 230 V 10 A 5 x 1 mm² 230 V / 400 V 230 V 16 A 4 x 1, 5 mm² OVEN LAMP REPLACEMENT Before replacing the lamp take care that all control knobs be on "off" position « 0 ». Disconnect the appliance; watch that the oven be cool. This lamp of 15 W, convection E 14 (230/240V) is a special lamp for "higher" temperature, up to 300°C. It is supplied on order, by your After Sales Service. [. . . ]