User manual ZANUSSI ZD851I

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. s s Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. [. . . ] To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. US32 A RC01 11 PBA08GB Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see Programme Chart on the following pages), so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. Do not prewash dishes under running water. Partial load (to be completed later in the day). 25 g / Main wash up to 65°C 1 cold rinse 1 hot rinse up to 65°C / / 1 cold rinse (to avoid food scraps from sticking to dishes). * Testing programme according to IEC 436/DIN 44990 Programme: Normal 65°C with prewash with detergent type A; Recommended setting of rinse aid: 3. Recommended quantity of detergent: 25 g in the dispenser 5 g on the dispenser lid. glasses and crockery (except pots) so that you may re-use them promptly. ** This is a special programme for quick washing (approx. 52 minutes) a full load of lightly soiled dishes, 13 PWP22GB Operating sequence 1. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 15 PMC01GB External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water; 2. Leave the door ajar to prevent the formation of any unpleasant smells; 4. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge; 4. Pull the machine out together with the hoses. Avoid over tilting the machine during transport. 16 PMC02GB Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. [. . . ] No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. [. . . ]