User manual ZANUSSI ZDI4041W

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q Conservation In the interest of the environment: q q q q q This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. UI57 UI12 The cutlery basket Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Cutlery should be placed in the removable cutlery basket with the handles facing downwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together. Silver cutlery tends to go black if mixed with steel cutlery. Place it in the cutlery basket separate from the others. RC01 When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. UI08 7 Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. Do not prewash dishes under running water. For best washing results Before loading, remove all scraps of food and soak very heavily soiled pots and pans. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. D Moving the machine MA02 MA08 Cleaning the large filter (Every week) If necessary clean the large filter (A) on both sides under running water, using a brush. To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. Refit the filter following the above instructions in reverse order. If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. E A F MA03 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 11 Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the following suggested corrective actions listed below. Symptom The machine will not start Solution q q q The door has not been properly closed. The plug is not properly inserted in the power socket. Ensure the mains water supply has not been cut off. [. . . ] The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. The locknut must be correctly fitted to avoid water leaks. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. [. . . ]