User manual ZANUSSI ZDT6253

[. . . ] DISHWASHER ZDT 6253 COP04 152975 52/0 INSTRUCTION BOOK UK Description of the appliance 1. Levelling spacers Upper basket stop Upper spray arm Salt container Large filter Detergent dispenser Control panel Rating plate Rinse aid dispenser 6 9 3 1 2 13 12 4 5 11 10 10. "SID" detergent dispenser (Super Intensity Dispenser) 8 7 IN84 The control panel In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open. Long "programme run" signal A continuous audible signal, heard only when you close the door, informs you that the washing programme is starting. [. . . ] This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine, which may cause corrosion. To fill: 1. To fill with salt, unscrew the cap of the salt container. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel (if provided), pour in the salt until the container is full. Do not worry if water over flows from the unit when filling with salt, this is quite normal. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. The salt container will require topping up periodically. According to the model, an indicator reminds you when filling with salt: A) The salt cap has a refill indicator window in the centre. A green float is clearly visible when there is salt inside the container, and almost disappears when the salt has finished reminding you to add salt. LE SA LT SA LZ SA L SE If your water is level 0 it is already soft and therefore there is no need to use salt. In this case adjust the water softener on level 1 without using salt. SR06 Only for dishwasher models with salt refill indicator light: if the water softener has been adjusted on level 1 without use of salt, the salt refill indicator light on the control panel will always remain illuminated when the machine is switched on. Each push button corresponds to a different level: Level 1 = programme push button 1 Level 2 = programme push button 2 Level 3 = programme push button 3 Level 4 = programme push button 4 Level 5 = programme push button 5 The adjustment of the water softener is possible only with the machine in setting mode. SR11 B) A salt indicator light on the control panel will come on when the salt has finished. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected. To select a different level, proceed as follows: 1. Press the ON/OFF push button and then press and keep pressed simultaneously for about 5 seconds the push buttons 3 and 5. The indicator light corresponding to the current level flashes. 2 Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Use of detergent Only use detergents specifically designed for use in dishwashers. We recommend the use of Finish detergents which are available in the following options: Finish Double Action Tablets. Each tablet has the exact amount of detergent required, simply place in the dispenser. Finish Powder recommended for every day use. Finish Liquid Gel ideal for every day use. [. . . ] Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose. Attention!Our appliances are supplied with a with a security device to protect against the return of dirty water back into the machine. [. . . ]